Hello Folks

I have read a couple of comments that the 6mm PPC is difficult to get to feed reliably in repeating rifles.

Can anyone share any experiences on this issue, either in respect to "factory" rifles or conversions ?? Are there any of the "mini" actions that this problem may particulary show up on e.g. Sako, CZ527/Fox.

Cheers - Foster

My Sako has never even burped once.

The CZ should be fine due to it's single stack design.

I have no exeperience with a "mini-mauser" yet, but will give that a whirl sooner or later.

LD

I rebarreled a Ruger 7.62x39 to 6mmPPC using a heavy contour Kreiger. No other alterations of any sort and it feeds perfectly.

I was fortunate enough to have one of the Sako "prototype" +1 repeater with the gloss finish and iron sights! Rifle was one of the most accurate I ever owned. Never noticed any difficulty at all chambering from the magazine.