The Accurate Reloading Forums
Clips for Remington 541 T
10 May 2015, 18:02
blaser93Clips for Remington 541 T
Are there any good clips out there for a 541 T
Mine are crap , hard to remove from rifle.
11 May 2015, 05:35
OkieNewtonI want to say I saw some on gunbroker a while back. I just put in 541 in the search. Was looking for a t or s model.
Keep yer powder dry and yer knife sharp.
13 May 2015, 03:40
analog_peninsulaThe only mags available are the crappy plastic factory models, which are known defective and everyone hates.
If you search around on the Internet, you will see a project from a few years ago to make metal magazines for the 541; but the project was shelved for whatever reason.
Sigh. Remington knows the magazines are garbage and does nothing. It defines their customer service in a nutshell.
analog_peninsula
-----------------------
It takes character to withstand the rigors of indolence.
13 May 2015, 06:27
jeffeossoARGHHH!!!!!!
oh, wait, you mean the remington uses stripper clips?
31 May 2015, 19:35
michael carrollebay has the plastic mags. also the mags for the nylon 77 are supposed to work. all of them are pretty shoddy stuff,though. good luck.
05 June 2015, 06:50
p dog shooterquote:
Originally posted by jeffeosso:
ARGHHH!!!!!!
oh, wait, you mean the remington uses stripper clips?
from Merriam-Webster
2clip
noun
Definition of CLIP
1
: any of various devices that grip, clasp, or hook
2
:
a device to hold cartridges for charging the magazines of some rifles; also : a magazine from which ammunition is fed into the chamber of a firearm 3
: a piece of jewelry held in position by a clip
21 September 2016, 09:51
GoWyoThere's a guy selling 3D printed mags on rimfire central. Kinda pricey.
Damn right its loaded, it makes a lousy club. -JW
08 December 2016, 16:47
Pa.FrankI have a 581 I bought in the 70's... Back then, DuPont owned Remington and the original mags were made of DuPont Nylon not run of the mill injection molded plastic. they were quite durable. Mine is still fine after 40 years of service.. I have a few after market mags that didn't hold up, but the original still works fine.
I doubt that even the new Remington branded mags arew made of DuPont nylon and are likely junk. That being said, I'd like to have a metal mag as well.
NRA Benefactor.
Life is tough... It's even tougher when you're stupid... John Wayne
08 December 2016, 20:15
Ole Miss GuyDoesn't Brownells have them in metal?
11 December 2016, 01:53
drhall762Some years ago I got brand new ones from Numrich, not that they have any left. Like most other treasures, they are out there somewhere.
Dave
In 100 years who of us will care?
An armed society is a polite society!
Just because they say you are paranoid doesn't mean they are not out to get you.
24 December 2016, 08:17
Dans40XCModified 513 steel mags work wonders to replace the plastic units.
btw-
clips aka strippers load thru the top of the receiver.
magazines load thru the bottom or side of the receiver.
24 December 2016, 22:10
watermanBut only 2/3 of the new steel 513 magazines actually work in a 513. There must be a rule out there that says "nothing is simple".