Does anyone know a source like Brownells for a 7.62mm Nato stuck case remover?

I searched their site and could not find one.

thanks, Andy

Remember...... there is a difference between a stuck case (case head still attached to case) and a seperated case (head pulls off leaving the forward portion of the case in the chamber or sizing die).

Different "remedies" required.

DaMan,

You are correct.

I need one that will remove a case that has been torn in two. No extractor available!

I had one for my Bren gun but it does not work with a .308 Winchetsr.

Andy

Andy, the broken case extractor that craigster recommended is what you'll need.

If you live close to a reputable gunsmith, I'd take it to him to pop it out for you.

Unless you are a gunsmith or armorer, you will probably only need the broken case extractor once and then it'll just gather dust until you forget about it.

Thankyou both,

That is exactly what I need.

I was using some old military (M60 machinegun brass) reloads that my HK would digest in an FAL, and new better.

Teaches me right!

Thanks again.

Andy