Johnny Ringo

Some where in the US constitution it's written that it's every citizen's duty to ignor and actively subvert any and all stupid laws.
If I were to ship you some extrusions, costing less then $100.00 US nobody would get their panties in an knot. I could possibly send you some castings in another package.
It ain't what you do it's what you call it.
Jim

Copper tubing end cap's = Jacket's
copper tubing end cap's cost about 50 to 75 cent's
each for 1/2 ..On the other hand jacket's that have an inside diam of 1/2 only cost 14 cent's and are custom made
go fig g g g er'that one out
so all your shipping are sealed copper tubing end's that you will later melt the lead out of and use as end cap's
in plumbing
well it's the bullshit story i spin...

It's just better if you order Lee mould or buy a single stage die from CH tooling--Dave davison

If you would like address's and email number's just ask it will run you about 10.00 for a mould or 100.00 for a single stage die to swage them.Then again with a swage your not limited to one bullet weight you can make them any weight you like . or you can buy 30 Cast mould's one for each weight of bullet for your rifle's diamter.

Just an idea

I have read on this forum that a shipping label of "machined steel parts" works to dissuade "curious/stupid/antagonistic/moronic individuals from inquiring to indepth. Some have been given a wee bit too much power in decision making, and revel in flexing their muscle. By the way, does customs or whomever inspecting these packages unwrap and rewrap them all?