THE ACCURATERELOADING.COM SMALL CALIBER FORUM

Accuratereloading.com    The Accurate Reloading Forums    THE ACCURATE RELOADING.COM FORUMS  Hop To Forum Categories  Rifles  Hop To Forums  Small Calibers    30-06 resize to 25-06 question.

Moderators: Paul H
Go
New
Find
Notify
Tools
Reply
  
30-06 resize to 25-06 question.
 Login/Join
 
new member
posted
I was sitting in the reload shop this afternoon resizing a few 25-06 cases. My stepson had left me some of his 30-06 brass... well why not free brass! I had no issues stepping from 30 to 25. I chambered a re-sized empty with no primer and felt no resistance in the bolt. I am not doing this for any reason other than an experiment. I know this was the origin of the 25-06 as a wildcat back in the day, but does anyone know of anything extra that has to be done after full length sizing to use these cases?
 
Posts: 10 | Registered: 16 March 2011Reply With Quote
One of Us
Picture of vapodog
posted Hide Post
quote:
does anyone know of anything extra that has to be done after full length sizing to use these cases?

Check for case length....trim if necessary and go shooting.


///////////////////////////////////////////////////////////////////////////
"Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery."
Winston Churchill
 
Posts: 28849 | Location: western Nebraska | Registered: 27 May 2003Reply With Quote
one of us
Picture of ramrod340
posted Hide Post
Like Vapodog said check for length. I would also make sure with the thicker neck I had enough neck clearance in my chamber


As usual just my $.02
Paul K
 
Posts: 12881 | Location: Mexico, MO | Registered: 02 April 2001Reply With Quote
one of us
Picture of Jerry Eden
posted Hide Post
Paul's right about the neck thickness. 25-06 brass is thinner in the neck than the 30-06. I don't know who the genius is that figured that one out, but check and ream.

Jerry


NRA Benefactor Life Member
 
Posts: 1297 | Location: Chandler arizona | Registered: 29 August 2003Reply With Quote
One of Us
posted Hide Post
quote:
anyone know of anything extra that has to be done after full length sizing to use these cases?


1. Anneal your new necks or they will split early.

2. Measure the diameter of a fired case and compair that to the diameter of a loaded (dummy) neck of your new cases. They will likely be fine but you HAVE TO KNOW, not guess. If the loaded diameter is smaller than the fired diameter you are good to go. If not, you will need to turn the necks to make them so.

Turning is preferable to reaming and there are lots of rational priced turners available these days. (I've tried several and settled on the Forster HOT-100.)
 
Posts: 1615 | Location: South Western North Carolina | Registered: 16 September 2005Reply With Quote
  Powered by Social Strata  
 

Accuratereloading.com    The Accurate Reloading Forums    THE ACCURATE RELOADING.COM FORUMS  Hop To Forum Categories  Rifles  Hop To Forums  Small Calibers    30-06 resize to 25-06 question.

Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia