THE ACCURATERELOADING.COM GUN CLEANING FORUM

Go
New
Find
Notify
Tools
Reply
  
Hot or Cold
 Login/Join
 
One of Us
Picture of smedley
posted
So here I was running a few rounds through the tube, Tubbs Final Finish to be exact, and after 5 rounds I would stop and clean. Now the barrel was not "HOT" but it were warm.
As I would poke a patch the brush some solvent though I would notice a slight "steam" exiting the muzzle.
This made me wonder if it is better to scrub when the barrel is warm or if when cold?
Not sure if the temp would effect the solution???

Thanks!


______________________

Smedley

______________________
From Audacity of Hope: 'I will stand with the Muslims should the political winds shift in an ugly direction.'
B.H.Obullshitter
------------------------------------
"Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery"
Winston Churchill
------------------------------------
"..it does not require a majority to prevail, but rather an irate, tireless minority keen to set brush fires in people's minds.." Samuel Adams
------------------------------------
Facts are immaterial to liberals. Twisted perceptions however are invaluable.
------------------------------------
We Americans were tired of being thought of as dumb, by the rest of the world. So we went to the polls in November 2008 and removed all doubt.....let's not do it again in 2012 please.
 
Posts: 3242 | Location: Cruising through the Milky Way at 98,000fps | Registered: 03 October 2005Reply With Quote
One of Us
Picture of 308Sako
posted Hide Post
Some Lik'em Hot


I do believe that the chemical action of the various solvents is enhanced by a warmer barrel. Too hot and vapor will not help. I have also seen weather where the solvent would freeze!






Member NRA, SCI- Life #358 28+ years now!
DRSS, double owner-shooter since 1983, O/U .30-06 Browning Continental set.
 
Posts: 3611 | Location: LV NV | Registered: 22 October 2002Reply With Quote
One of Us
posted Hide Post
Have shot with a number of serious competion shooters that make sure to put solvent in to work while the barrel is still hot from the last relay. Many like to let Kroil soak on the way home and then scrub.
 
Posts: 378 | Location: Atlanta.GA | Registered: 07 December 2006Reply With Quote
one of us
Picture of arkypete
posted Hide Post
I'll swamp out the barrel after firing the last 10 rounds through the AR10. Let it soak for 10 minutes and swamp out the barrel again. I let the rifle set check targets and then clean the rifle, leaving barrel wet/damp for storing in safe.
I clean the barrel prior to shooting.
Jim


"Whensoever the General Government assumes undelegated powers, its acts are unauthoritative, void, and of no force." --Thomas Jefferson

 
Posts: 6173 | Location: Richmond, Virginia | Registered: 17 September 2000Reply With Quote
One of Us
posted Hide Post
I could be nuts but my rifles seem to clean up better at the range when they are warm. Maybe becuase I am in the gunning/shooting mood. Maybe becuase I am not in a hurry before momma bear starts her bitching about stinking up the house.
 
Posts: 416 | Registered: 21 December 2005Reply With Quote
  Powered by Social Strata  
 


Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia