I have a 13" Encore barrel listed in the classifieds. This is a 30 Bellm chambered barrel.
Greg

[ 01-14-2003, 04:22: Message edited by: Greg K ]

This could be a good barrel for rechambering, as the case is only 1.4".

Greg, call Danny Campbell quick like before the season starts this weekend. He may be able to move it for you!

CNC Cartridge phone number: (618) 435-2855

You said earlier you were having trouble with accuracy. Did you get that resolved, or is that the reason for letting it go?

Due to the large shoulder diameter, one would have to be quite careful about rechambering it. It may leave a ring in the new chamber where the old chamber ended.

I wish I had seen your post earlier, but either way, contact Danny.

Any accuracy problems should be highly resolvable. Should be a tack driver. All of the .30 Bellm barrels have shot well so far as I know. Again, Danny is working closely with these and knows first hand. I have turned the Illinois end of it over to him entirely.

Mike

Already contacted Danny by email. Bought a used SSK 300 Whisper about a month ago that is shooting 1.4" five shots out of the box with Cor Bon factory loads at 100 meters. This was on a breezy day with temps in the 20's.
I worked with the Bellm all summer and fall, factory loads, and reloads. Put 300 rounds through it. Tried different scopes, got a trigger job, and I can't match the Whisper barrel's accuracy. The Whisper is going hunting tomorrow. Don't need two barrels.
Greg