The Accurate Reloading Forums
Contender Triggers

This topic can be found at:
https://forums.accuratereloading.com/eve/forums/a/tpc/f/6121043/m/65010439

20 September 2002, 07:50
Mike Bellm
Contender Triggers
Starting Headstamp's Contender trigger job yesterday, I took the opportunity to take pix of how I undercut the sear surface on the trigger and put the pic on the store under Tools, with the first item there being the 1/4" square Diamond EZE Lap.

I am showing how to use the body of the trigger and the 1/4" dimension of the lap to set the angle. The 1/4" Wyoming then follows the same angle as the 1/4" lap cut and polishes on the same angle. I did not get the Wyoming Stone pic of the polishing up last night..... blame it on Sean's late night call! [Eek!] ..... which I also indulged in. [Wink]

I'm going to make the store as informative as I can since it is an easy way for this nimrod to get pics up without having to manage the main site's complexities or burden 1buba too much with all the stuff I want to put up.

Excuse some of the uncropped photos.... haven't quite figured out managing image files yet.

Check it out.

Mike
20 September 2002, 09:58
<Headstamp>
Nice job on the new site, Mike. Seems to be laid out better and the Pix are great too.

I won't charge you for using my trigger group either. [Wink]

Regards
20 September 2002, 13:23
Sean VHA #60013
quote:
Originally posted by Mike Bellm:
I did not get the Wyoming Stone pic of the polishing up last night..... blame it on Sean's late night call! [Eek!] ..... which I also indulged in. [Wink]

Aye! A good time was had by all [Big Grin]

Plotting the ultra accurate/ultra quiet/ultra fun 22short 14" which I will use on miniscule yet ultra anoying varmints was a fun intellectual excercise [Big Grin] [Big Grin] [Big Grin]