Working on a load for my 308. I believe I have found the combination. PMC brass, H4895 powder, Fed 210M primers and 150 gr Nosler Ballistic tips. Three (5 shot) groups, the largest with one flyer measured .630" and the other two were .510", measured center to center with calipers. All at 100 yds off of micro rest and sand bags. Burris 3x12 LER also. Powder volume was not maximum but within 1 grain of max. Next step is to check velocity. **one note, I did try H BLC-2 but the pressures were tremendous (from stuck cases to cratered primers) I do not kow if it was a bad lot of powder but when you have to take a cleaning rod to knock the case out it was definatley to high.
TC