The Accurate Reloading Forums
400 grain lead bullets for 450-400 3"

This topic can be found at:
https://forums.accuratereloading.com/eve/forums/a/tpc/f/4911043/m/9781054191

07 August 2013, 22:24
stradling
400 grain lead bullets for 450-400 3"
I would like to find a supplier for bullets to plink with using my 450-400 double

any one know who might make sell em


Anyway it matters not, because my experience always has been that of---- a loss of snot and enamel on both sides of the 458 Win----
07 August 2013, 22:38
Doubless
Sent you a pm...
08 August 2013, 02:14
stradling
got it thanks


Anyway it matters not, because my experience always has been that of---- a loss of snot and enamel on both sides of the 458 Win----
08 August 2013, 07:32
470Evans
For plinking I use the .411 300gr Hornady bullets made for the 405 Win. Use the same powder and charge that you use for the full 400gr load.


2010 Sapi Elephant Hunt
09 August 2013, 06:32
crshelton
The Hornady 210 Grain XTP pistol bullet for the .41 mag pistol is also a good one. You can load it down to .41 mag velocities and up well above 2000 fps as desired; the lower velocities have less recoil and are more pleasant to shoot than the 300 grain Hornadys which have been discontinued for now.
You can also order the 210 grain cast bullets from Penn Bullets ( http://www.pennbullets.com/41/41-caliber.html )
and save even more $$. Smiler


NRA Life Benefactor Member,
DRSS, DWWC, Whittington
Center,Android Reloading
Ballistics App at
http://www.xplat.net/
14 September 2013, 13:26
N E 450 No2
quote:
Originally posted by 470Evans:
For plinking I use the .411 300gr Hornady bullets made for the 405 Win. Use the same powder and charge that you use for the full 400gr load.


That is the 75% Rule.

That method has worked great in several different 450/400 double rifles. tu2

Your velocity should be around 2250 to 2300fps or so, about the same as the 405 Winchester.

Kills pigs, deer, etc. like the Hammer of Thor...


DOUBLE RIFLE SHOOTERS SOCIETY
14 September 2013, 13:34
N E 450 No2
If you want a lighter hunting/plinking load, take the 41 Mag bullets and load them over IMR 4198.

These loads were invented for Black Poweder Express rifles, to duplicate the old original Nitro For Black loads.

Start with 44gr of IMR 4198, and work up till they regulate and hit with the sights at 50 yards.

WARNING!!!, WARNING!!! YOU MUST USE DACRON FILLER WITH THIS LOAD!!!

THE DACRON MUST BE COMPRESSED BETWEEN THE POWDER AND THE BULLET.

Usually this is around 12 grains of Dacron in the 450/400.

The Dacron does not melt in the barrel, it does not even char.

I have shot several hundred of these loads in double rifles with no problems.

Velocity will be around 1700fps.


DOUBLE RIFLE SHOOTERS SOCIETY
16 September 2013, 03:47
Doubless
FWIW, shooting a 200-220 grain handgun bullet in a double rifle regulated for 400-grain bullets at about 2100 is going to result in point of impact being well off the target. If one is plinking just for the joy of shooting that may be acceptable, but it appears to me one is far better off shooting the original weight bullets.

But I could be wrong...
16 September 2013, 04:06
N E 450 No2
In my 450/400 3 1/4" double rifle, the 210 Sierra 41 mag bullet hits to the sights at 50 yards and shoots a group smaller than the palm of my hand.
The load is 44gr of IMR 4198, with 12 grains of Dacron filler.

In my 450 No2 double rifle it shoots spot on with the 300gr Remington HP [for the 45/70], with 52gr of IMR 4198, and 15 gr of Dacron.
Velocity is 1878fps.

These are both Nitro for Black type loads pressure wise. They are very accurate and have very mild recoil.


DOUBLE RIFLE SHOOTERS SOCIETY
16 September 2013, 04:31
Grenadier
http://www.montanabulletworks.com/BB_40_caliber.html




.