one of us
| I was about to ask the same question as well. I was after a set of 30mm rings to use my 2.5-10X scope at the range. I will check out the Warnes |
| | | Posts: 618 | Location: Singleton ,Australia | Registered: 28 November 2002 | 
IP
|
|
one of us
| On the website ,it didnt show any mounts to fit on the Brno 602 dovetails. Do they make ones to fit the dove tails and recoil groove on the 602s? |
| | | Posts: 618 | Location: Singleton ,Australia | Registered: 28 November 2002 |
IP
|
|
one of us
| cr500 I found these in another section of the above site. web page The Warne site also shows specific QD rings for the CZ [16mm and 19mm CZ - I'm assuming this is the measurement across the top of the mount - mine is 19mm on the zkk602] I can't tell from the Talley site if they offer the same models though. Les |
| | | Posts: 1261 | Location: Clearwater, FL and Union Pier, MI | Registered: 24 July 2003 |
IP
|
|
one of us
| LHowwel
Thanks for posting the link ,they look good. I might look into them for mine. Are they steel or die cast? Anyone used the Lynx mounts? |
| | | Posts: 618 | Location: Singleton ,Australia | Registered: 28 November 2002 |
IP
|
|
one of us
| The local distributor has 1" and 30mm Lynx (B-Square) QD rings in Medium and High heights for the CZ 527 and CZ 550. $35 plus shipping (no returns!!).
E-mail me if you want some. |
| | |
