I'm working on a 70 caliber project and need a .700 caliber bullet mold. Something similar to the Woodleigh 1000gr SP would be fine.

I saw where the .700WTF was loaded with lead bullets, but there was no mention of who's mold was used. Rather than have someone make one from scratch I would rather buy one from a Company that has already made such a beast. And what about .700 gas checks?

Tony Rumore
Tromix

You can get a 69cal minie bullet mold, have it reamed out,
cut off base pin and cast with it. Use hard alloy
which we tested a couple in our 700HE Long which
is faster than any other 700 and they work.

You can get jacketed 700s made reasonable by
Copperhead Custom In Az.Ed

NEI makes a .715, 1200grain bullet mold, #398B that could be easily sized down to .700 with a push through sizer die.