Hi!
I was thinking that if I buy a brno CZ550 Magnum rifle next year and then when I have enough money I will build it to a .600 Overkill.
I was thinking on to give it to some gunsmith here in sweden and then he make it to a .600 OK is it possible?
What do he have to do with the CZ to make a .600OK?? a new barrel and then what?
What would the hole rifle cost?
If we not count the work that the gunsmith do.

And what does the hornebear brass cost? and is it possible to get them to sweden???
//OK

The smith would have to install a new barrel. If you like it to feed I guess there is some need of magasine work to be done.

You can order Horneber brass from germany to sweden. I have done that.

A Lothar Walther barrel is around 2000sek, a chamber reamer is about 2000sek allso and the loading dies is about 2000sek. Bras is less than 1000sek for 20pcs I would guess. Bullets are not cheap...

Ok?

Alright.. Thanks for the info!
But does the horneber brass cost so much??

I would also want info from Robgunbuilder. He has made the .600 Overkill..
Rob? What should be done on the brno??
And does it matter if the brno CZ550 rifle is in 375H/H 416 rigby or in the 458WM do make it to a .600 Overkill???
//OK

I remember a while back he (Rob) mentioned a bigger rifle than the .600 OverKill.
I personally call it the .700 INSANITY!!!!!!!
A necked up and improved .50 BMG