I got some 450gr Woodies

The Accurate Reloading Forums

This topic can be found at:
https://forums.accuratereloading.com/eve/forums/a/tpc/f/4711043/m/633104298

16 July 2008, 09:43

PoppaW

I got some 450gr Woodies

So I finally bought some 450gr wooliegh bullets for my Rigby and I did a search and can't find any load info other than back off a 400gr load and hope for the best!!! IF this is all we have then I guess I will go pour the powder but i'm sure someone has broken this ground already. Any help???

16 July 2008, 13:58

jetdrvr

You might try PM-ing Ray Atkinson for information, or email Woodleigh. Ray tested that bullet for Woodleigh. Check Woodleigh's website for contact information.

16 July 2008, 14:38

Will

quote:
can't find any load info other than back off a 400gr load and hope for the best!!!

That is what you will probably wind up doing anyway. Even the same powder can vary from Lot to Lot, and every rifle is different, so why not?

-------------------------------
Will / Once you've been amongst them, there is no such thing as too much gun.
---------------------------------------
and, God Bless John Wayne. NRA Benefactor, GOA, NAGR
_________________________

"Elephant and Elephant Guns" $99 shipped.
“Hunting Africa's Dangerous Game" $20 shipped.

red.dirt.elephant@gmail.com
_________________________

If anything be of note, let it be he was once an elephant hunter, hoping to wind up where elephant hunters go.

16 July 2008, 16:49

Code4

Definantly contact Woodleigh direct. They usually answer most questions with solid advice.

16 July 2008, 22:38

x2mosg

This is the reply I got when I contacted Woodleigh back at the end of January:

We haven't tried 4350 with the 450gr bullets.
The loads we recommend as follows:-
Federal 215 primer
450gr SN bullet
94 grains IMR 4831 for 2304 fps
94 grains H 4831SC for 2300 fps
100-105 grains H1000 for 2100-2200 fps.
For FMJ reduce by 3 to 5 grains then work up if necessary.
Regards,
Geoff McDonald.
WOODLEIGH BULLETS
PO Box 15, Murrabit, VIC, 3579, Australia
Ph. 61 3 5457 2226
Fax. 61 3 5457 2339
zedfield@iinet.net.au
www.woodleighbullets.com.au

That's what they recommend unless they've done more testing since. Ray Atkinson only loaded for the 416 Rem., I already talked to him about that.

David

17 July 2008, 08:55

PoppaW

Thanks for the info. It gives me a good start.

17 July 2008, 23:39

Atkinson

I have only used them in the 416 Remington and 404 Jefferys for hunting cape buffalo and plainsgame, and Bison, elk and deer... and lately in my new 416 Ruger I am shooting them on paper. They perform very well in the .416 Ruger much to my surprose and I get an easy 2350 FPS with them and betting I can get 2400 FPS within reasonalble pressure. We will see.

Sorry, but have not used them in the .416 Rigby but I would think that 94 to 95 grs. of IMR-4831 would work, cut back about 15% and work up.