making any in .510 diameter? would like to try new designs in the 50bmg

AC

No production (I think )
I did not test shoot them yet I will do that later this week.
I will use phone books about 6 feet of them and then a thick steel plate at the end.

I only made 2 solids based on the Square hole bullet that is why they have a boat tail.

I have a hard time finding a place where I can test my bullets. all the shooting ranges have rules No phone book test and so on. I wish I was back at the farm in NY


Cheers,

Andr�

Andre,

Have you fired off any of design one through three? If so how did they do? When will you be going into production?

ASS_CLOWN

Gentlemen

The No 3 design.

I made the grooves a bit smaller and not so deep as the No 2 design. Bullet is a bit more heavy due to this the weight is now a bit more then 500 grn. sorry for not being precise but I only have a 505 from RCBS
Hole is SQUARE 0,125 inch / 3,20 mm
Bullet over all length is 1,464 inch / 37,20 mm





This is the EVO of the Bullet the No 3 design is 2nd from right.




First design of the Cup point solid.


Cheers,

Andr�