Good day People,

Please advise on solutions for trimming 577NE & 600NE cases and pulling bullets?
I've scoured the internet..
Many thanks!

Hello, Wowo. These items are available, (or at least they were when I ordered them a few years back), from RCBS. If you can get them, they will be a special order. The bullet pullers will be the collet style, and will require that you purchase the .50 BMG puller, (part number 9448), to accommodate the large collets required for .600 NE and .577 NE. The trimmers will be file trim dies, also special order. My experience has been that these relatively straight walled cases do not expand very much. As a consequence, I have not found it necessary to trim on any kind of a regular basis. Additionally, I know that there are much cheaper ways of pulling bullets than the RCBS route. Other members of this forum have covered these methods in the past. Hope this helps. Cheers. Chip.