Has anyone installed the Wiesner CZ 550 FP magazine floorplate for the 416 Rigby and used it either modified or not to hold an extra round in a 500 Jeffery?

http://www.wisnersinc.com/cust..._gun_parts_built.htm

Thanks,

Chuck

I've use them on Brno ZKK602 (precursor to the CZ550), 375H&H and 458Lott, work fine, add one round to the capacity of each.

Thanks, do they come blued or in the white?

Chuck

White, unpolished, when he has them. He was out last time I checked (a few months ago) and did not have a production run schedualed for awhile. I'd call his wife at the front desk, she is very knowledgeable, and he posts here from time to time.

Thanks again, I'll do that ...

Regards,

Chuck

Good to know Jim is back at it!
Thanks for the tip, chuck375.
I could use several things in that list:

Custom Gun Parts
MF 375 Mauser Follower (375 H& H) $ 34.75
120K 2 Position Winchester model 70 conversion kits (fits Mauser 98) $ 33.00
140K 2 Position Winchester model 70 conversion kits (fits Springfield 1903) $ 33.00
170K 2 Position Winchester model 70 conversion kits (fits Mauser 96) $ 33.00
1909 FP Floor Plate, replacement straddle type fits 1909 Argentine Mauser $ 50.00
CZ550 FP Floor Plate, replaces factory 375, for CZ 550, (pocket plate, 6 round) $ 65.00
CZ550 FP Floor Plate, replaces factory 416 for CZ 550, (pocket plate, 4 round) $ 65.00
458 RS Rear Sight, copy of Winchester pre 64 M70 African rear sight $103.69

And if you have any Mark X Mausers, he makes straddle floorplates like those for 09 Argentines that are not shown in his catalog.

Our very own Gunmaker turns out a run of 1909 straddle type "round bottom" bottom metal fometime to time.

Very nice stuff.