375 if you don't mind, I'd be interested in getting the load data you use for your 375um.

Also forgot to mention earlier, my 1st scope on the Rem was a S&B 1.5-6x, not enough eye relief. I had to be very careful to keep it out of my face. It didn't hammer me, just let me know it was there about every 3rd shot. Switched to a LPS in the same power and haven't looked back. The Sako will wear a 2.5-8 Leupold when it comes. I'm going crazy waiting, should be here any day...

billy375:

You shot this PRONE? Yikes.
I have a question about the Hogue stock --- Did you get the pillar bedded or full bedding-block version?

I've had my rifle for almost a year and haven't finished fiddling around with it yet, let alone firing it. I'm anxious to get it out and try it, then post pix...

The action went into an older Remington arylon synthetic stock and I had the 'R3' recoil pad installed, but I've considered getting the full-bedding block Hogue for it and probably will.
I took off the sights and installed a Mounting Solutions Plus tactical base with Weaver Grand Slam rings for the Leupold 4.5-14x40 A/O scope. Lotta scope on this gun, but I had it and will have to put some tape or rubber cement in the rings to help hold it in there, I think.
I had to do some fitting to get the triggerguard/mag box to go in just right. I've also condidered filing a flat at the the front of the stock to install the front sling swivel there so I don't rip up my left hand during recoil.
Once it's all detailed and tightened up, I'll take the rifle out to the range and see what kind of monster I've created.
Curious about the Hogue stock, though.