THE ACCURATERELOADING.COM BIG BORE FORUMS


Moderators: jeffeosso
Go
New
Find
Notify
Tools
Reply
  
Barnes vs Northforks Login/Join
 
One of Us
posted
I have read some horror stories about the Barnes bullets causing copper fouling, but don't remember ever reading about Northforks doing the same. Aren't they both all copper bullets? Why the differences? I am going to start reloading all copper for my 416 rem. I live in California, the no lead state. Thanks for any shared experiences. Gary
 
Posts: 469 | Location: central California | Registered: 26 October 2006Reply With Quote
one of us
posted Hide Post
Gary
North Fork Softs are not 100% copper, they are a bonded lead core bullet.

NF Solids and Cup point bullets are lead free.

I have shot them in my double and did not notice any excessive fouling.If your pareticular barrel fouls badly with Barnes bullets, jusrt clean it with a good copper remover and follow that with J&B Bore Paste or Remclean, and then follow that with Prolix to remove the residue of the first two.


DOUBLE RIFLE SHOOTERS SOCIETY
 
Posts: 16134 | Location: Texas | Registered: 06 April 2002Reply With Quote
One of Us
posted Hide Post
I found the old Barnes X bullets to foul horribly but that has not been my experience with the Triple Shocks, they don't seem to foul any worse than anything else in my rifles. Given how well the TSXs shoot in most rifles I can't see a reason to ever use the original X bullet unless for some reason that was all your rifle would shoot well.
 
Posts: 3071 | Registered: 29 October 2005Reply With Quote
one of us
Picture of fredj338
posted Hide Post
For the restricted areas in Kalif. you'll have to load the Barnes or the new Nosler all copper. The NFs are lead bonded core & would not be "legal". Like adrook, I hated the early Barnes 'X', fouled badly & accuracy was always spotty. Th enew TSX & TTSX should be better but I am just recently giving them another look.


LIFE IS NOT A SPECTATOR'S SPORT!
 
Posts: 7752 | Location: kalif.,usa | Registered: 08 March 2001Reply With Quote
One of Us
posted Hide Post
I shoot a lot of Triple Shocks in several different rifles with no fouling issues at all. As others have noted, the original "X" bullets did cause problems with some rifles, but I just haven't seen it with the TSX.
 
Posts: 373 | Location: Georgia, USA | Registered: 31 August 2007Reply With Quote
One of Us
Picture of retreever
posted Hide Post
I consider the TSX a bullet for the 21st century... I like both the TSXand the North Forks...


Mike


Michael Podwika... DRSS bigbores and hunting www.pvt.co.za " MAKE THE SHOT " 450#2 Famars
 
Posts: 6768 | Location: Wyoming, Pa. USA | Registered: 17 April 2003Reply With Quote
one of us
Picture of Andy
posted Hide Post
Gary,

You could shoot the north fork cup point which is a copper bullet.

I dont think they are available in less than .366 (9.3mm).

I found that IMR 4350 did leave some copper fouling in my 450 Dakota using the NF. No other powder did this. wierd.

The Barnes X was a no go in my rifle. Took literally hours to unslime the barrel.

The TSX was much better.

Not as good as NF CP but OK.

Andy
 
Posts: 1278 | Location: Oregon | Registered: 16 January 2004Reply With Quote
One of Us
posted Hide Post
Just to be clear. NF comes in a solid and a cup point solid in addition to the bonded lead core.
 
Posts: 404 | Registered: 08 May 2005Reply With Quote
one of us
Picture of fredj338
posted Hide Post
quote:
Originally posted by I Bin Therbefor:
Just to be clear. NF comes in a solid and a cup point solid in addition to the bonded lead core.

As of the sale of NF, cup points were not available in smaller calibers.


LIFE IS NOT A SPECTATOR'S SPORT!
 
Posts: 7752 | Location: kalif.,usa | Registered: 08 March 2001Reply With Quote
  Powered by Social Strata  
 


Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia