I just aquired an A-square Hannibal model in 416 Rigby. It appears that the trigger-guard and floorplate are original equipment from the Enfield action that A-square used for their rifles. The magazine holds three rounds and will almost hold a fourth. Does anyone make a Rigby style floorplate for the
Enfield that would increase the magazine's capacity to four rounds. As an alternative, any suggestions as to a source to modify the present floorplate to a Rigby style.
Thanks for your help.

PME does, or at least used to, also try Ted Blackburn.

Congratulations on your acquisition!! You should post a photo.
If you can't find anyone who can carve you some bottom metal check out John Ricks, he posts here too.

------------------

[This message has been edited by Roger Rothschild (edited 01-23-2002).]

I asked Blackburn and he said he does not make any Enfield stuff.

His line is for model 70, model 98, Dakota, Hartman & Weiss and Granite Mountain Arms.

Try London Guns in N. California. They have drop magazine bottom metal for Enfields. - Dan