What brand/model are folks around here using?

I have 2 older models that I use leupold on,I think the newer models take a different set because they have a rounded receiver.
For weaver style the newer models take 2 #46 bases.

I have a stainless model 10ML-II and I'm using a set of Burris bases for the model 10 and 110 series along with stainless Burris rings that have #8 allen head screws.

IF I recall correctly, they are low rings and it puts my Nikon 3-9x- 40 in the lowest spot possible. It does make getting to the primer a little more difficult, but it works just fine if the primers don't stick in the bolt. If they do, a knife or small screwdriver pops them right out.

I just shot mine yesterday and I averaged 1.2" at 100 yds for seven 3 shot groups using 42gr N110, MMP short black sabot, 250 gr XTP and a Win 209.....I'm happy to say the least!!

GOOD LUCK with ML season!!

Thanks guys. I did find that this new one has a round rear bridge, unlike my older one that had a flat rear bridge. Weaver S46 bases will be ordered and then I hope to get started with load workup. I can't find any VV110 locally, but did find some 4759 so will try that and some 5744 I have.
I hope my scope will clear the rear sight base, I removed the blade insert but haven't seen any way to get the base off the barrel. My older one came off in one piece, but this new one seems to have the base permanently attached to the barrel.