THE ACCURATERELOADING.COM MEDIUM BORE RIFLE FORUM


Moderators: Paul H
Go
New
Find
Notify
Tools
Reply
  
30/30 reloading data
 Login/Join
 
one of us
Picture of Tanoose
posted
Looking for data on the 30/30 using 180 grain bullets out of a single shot rifle for deer 100 yds max. Which 180's work well with 30/30 velocitys
 
Posts: 869 | Location: Bellerose,NY USA | Registered: 27 July 2001Reply With Quote
One of Us
posted Hide Post
Funny you should mention that.

YOu can use data for a 170 and back off about 5 %.
One of the most accurate powders that I have found for the 30/30 tho has been SR 4759, from IMR.

I have done load data for the 170 and 180 and the 220 grain round noses, single shot loading. Bullets were seated to the cannelure. Large rifle primers used. ( CCIs).

This is out of a Model 94s 20 inch barrel.

11 grs: 992 fps
12 grs: 1120 fps
13 grs: 1243 fps
14 grs: 1361 fps
15 grs: 1447 fps

16 grs: 1562 fps
17 grs: 1633 fps
18 grs: 1753 fps
19 grs: 1817 fps
20 grs: 1876 fps

21 grs: 1936 fps
22 grs: 2001 fps
23 grs: 2096 fps
24 grs: 2151 fps

Work up to the these loads. These were safe and fed singlely in a Model 94 winchester, 1966 production.

Bullets were seated to the cannelure, so will not cycle in a lever action, as they are too long.

Accuracy was fantastic for this rifle, which is usually horrible. Definitely the most accurate powder I have tried reloading a 30/30.

Pressure should be safe as I have also worked up 220 grain Round Nose loads using up to the same volume of powder, 24 grains.

Even though they would not cycle in a 30/30 the breech had no problem swallowing the bullet seated longer than normal 30/30 lengths.

All cases extracted easily and resized full length in the sizing die easily also, indicating no excessive pressure.

These load were with a Round Nose bullet but also have done the same with Remington Corelokts, just not done the chronograph work with that bullet.

Cheers and good shooting
seafire
 
Posts: 16144 | Location: Southern Oregon USA | Registered: 04 January 2005Reply With Quote
one of us
Picture of asdf
posted Hide Post
Given the modest speed and the short distances you mention, I suspect any of the RN bullets would do. Hornady makes them.
 
Posts: 980 | Location: U.S.A. | Registered: 01 June 2003Reply With Quote
one of us
Picture of Reloader
posted Hide Post
If your talking 180s, the velocity isn't going to be very high so, I would definitely get a easy expander. Since it is a single shot I would try the NBTs. They should till open fine at those low velocities. I have had the best accuracy w/ Remington CLs and H4895 out of my Marlin 336. If I had a single shot 30-30, I'd probably shoot the Pointed bullets out of it but, at the range you are talking the round noses will work fine.

Good Luck!

Reloader
 
Posts: 4146 | Location: North Louisiana | Registered: 18 February 2004Reply With Quote
  Powered by Social Strata  
 


Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia