THE ACCURATERELOADING.COM MEDIUM BORE RIFLE FORUM


Moderators: Paul H
Go
New
Find
Notify
Tools
Reply
  
25.06 hunting load
 Login/Join
 
One of Us
posted
Looking for accuracy first and than leathality with a new load for a 25.06 This will be used for deer hunting primarily with hogs/varmints thrown in the mix. What bullet/bullet weight and powder would you recommend? I thought about H4831 and a 120 Hornady BTSP? Thanks Esox357.
 
Posts: 180 | Registered: 15 August 2005Reply With Quote
one of us
posted Hide Post
Well, my go-to load for my 25-06 has been a 100 grain Nosler Partition in front of a max load of IMR 4831 for a number of years now.

I have killed a BUNCH of wild hogs with this load, and deer, antelope, coyotes, bobcats, etc.
It kills wild hogs a lot better than you would think a .257 caliber rifle would.

I have also had good luck using the 115 grain Nosler Ballistic Tip in front of a case full of IMR 7828. This has been especially good for me shooting antelope, but has dropped a few pigs as well.

Most recently I have had to work up loads with all copper bullets due to the STUPID California regulations. I am getting very good groups with the 100 grain Barnes TSX with exactly the same load I was using with the 100 grain Partition. The Barnes 100 TSX even hits the same place as the Partition.

I use Fed 210 primers with the IMR 4831 loads, and Fed 215M primers with the IMR 7828 loads.


R Flowers
 
Posts: 1220 | Location: Hanford, CA, USA | Registered: 12 November 2000Reply With Quote
One of Us
Picture of vapodog
posted Hide Post
Hornady's 120 Hollow point....end of conversation!


///////////////////////////////////////////////////////////////////////////
"Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery."
Winston Churchill
 
Posts: 28849 | Location: western Nebraska | Registered: 27 May 2003Reply With Quote
One of Us
posted Hide Post
I am very big on the 25-06. I shoot deer and groundhogs. I fooled with a lot of combinations of powder and bullets. The best overall load for me has been 58.4 grains of RL-22 and a Hornady 100 grain spire point. This is fairly tough bullet and gives me complete penetration on deer. It is my favorite deer load. I think this load gives me 3300 and change in velocity. Outstanding accuracy.
 
Posts: 831 | Location: Virginia | Registered: 28 January 2005Reply With Quote
One of Us
posted Hide Post
100gr Barnes TSX with 53gr of IMR-4350 with an OAL of 3.24"

120gr Nosler Partition with 54gr of IMR-7828 with an OAL of 3.25"


Free men should not be subjected to permits, paperwork and taxation in order to carry any firearm. NRA Benefactor
 
Posts: 1652 | Location: Deer Park, Texas | Registered: 08 June 2005Reply With Quote
one of us
Picture of Dr. Lou
posted Hide Post
I have been happy using 115 NBTs and IMR4831, but I want to try the 100 TSX and 110 Accubonds. Lou


****************
NRA Life Benefactor Member
 
Posts: 3316 | Location: USA | Registered: 15 November 2001Reply With Quote
One of Us
posted Hide Post
Here is a consistant load.

[IMG:top] [/IMG]


There are no fleas on the 9.3s

http://www.blaserbuds.com/forum/
 
Posts: 490 | Registered: 01 February 2007Reply With Quote
One of Us
posted Hide Post
100 gr TSX with 52 gr. RL-19.
 
Posts: 283 | Location: SW Oregon | Registered: 12 June 2004Reply With Quote
one of us
posted Hide Post
100 gr Partition w/52 gr H4350. Work up as usual.
 
Posts: 1324 | Registered: 17 February 2004Reply With Quote
One of Us
posted Hide Post
Back when I was hunting with a 25-06,I always got the tightest groups and highest velocities with IMR-4350.My favorite load was 51.2grs. of IMR-4350 with a 120gr. bullet with chronograph velocity of 3100fps.A word of caution loading for the 25-06,because it is very overbored,take great care in loading it specificy for your rifle,weigh each charge carefully and accurately and always work up to any given load.
 
Posts: 359 | Location: Corpus Christi,Texas | Registered: 19 April 2004Reply With Quote
one of us
posted Hide Post
51.0 grs. IMR-4831 & 117 gr. sierra
 
Posts: 1137 | Location: SouthCarolina | Registered: 07 July 2004Reply With Quote
One of Us
Picture of MickinColo
posted Hide Post
quote:
Originally posted by ron williams:
Here is a consistant load.

[IMG:top] [/IMG]


Good shooting.

Sometimes you just need to know what your rifle will do. The three shot groups are interesting, but what is your average over all?
 
Posts: 2650 | Location: Lakewood, CO | Registered: 15 February 2003Reply With Quote
one of us
posted Hide Post
quote:
This target tells me more about the rifle then any 3 shot test groups I’ve shot with it.


Mick: I agree that a group with lots of shots tells you a lot about a rifle's capability. And your rifle obviously has lots of capability.

But if we are talking about hunting rifles...where it will consistently place the first 2 or 3 shots from a cold (clean or semi-clean) barrel may be more significant that how it will group at the range with a barrel of unknown temperature (based on time/temp between shots)

IMO, multiple 3 shot groups taken on different days over time, in different weather conditions, barrel conditions, etc. are a better indication of a good hunting rifle than lots of shots at the same target with the same rifle on the same day.
 
Posts: 1416 | Location: Texas | Registered: 02 May 2003Reply With Quote
One of Us
Picture of MickinColo
posted Hide Post
quote:
Originally posted by olarmy:
quote:
This target tells me more about the rifle then any 3 shot test groups I’ve shot with it.


Mick: I agree that a group with lots of shots tells you a lot about a rifle's capability. And your rifle obviously has lots of capability.

But if we are talking about hunting rifles...where it will consistently place the first 2 or 3 shots from a cold (clean or semi-clean) barrel may be more significant that how it will group at the range with a barrel of unknown temperature (based on time/temp between shots)

IMO, multiple 3 shot groups taken on different days over time, in different weather conditions, barrel conditions, etc. are a better indication of a good hunting rifle than lots of shots at the same target with the same rifle on the same day.


I wouldn’t disagree with you.
 
Posts: 2650 | Location: Lakewood, CO | Registered: 15 February 2003Reply With Quote
One of Us
posted Hide Post
I have a old style Ruger in 25-06 that I guess I have 20 years now. I've gotten other rifles since then but I absolutely love that Ruger. My most accurate load I found is 57.5 grs. of Re 19 with a 100 gr. ballistic tip. I know this is pretty hot but I don't have any pressure signs and I started at 55 grs. and went up in 1/2 grain increments. The only other bullet that was close to the ballistic tip in accuracy was the Hornady 100 gr. SP. Good luck and enjoy your 25-06....PaLuke
 
Posts: 71 | Location: Hegins,PA | Registered: 28 June 2006Reply With Quote
one of us
posted Hide Post
Esox

I have never used a 25-06, but I have seen a few in action.

Also I have used a 243 and a 257 WBY Mag quite a bit.

IMHO when you throw wild pigs into the mix, things change in a major way.

You can never go wrong with a Nosler Partition.

They are not too expensive, they open up at long distance, and they will not "blow up" if shot into tough game up close.

Also I have NEVER had a problem getting them to shoot very good groups in hunting rifles.

So which ever Nosler Partition shoots best in your rifle is the one I would use.

Just remember you can NEVER go wrong with a Nosler Partition, NEVER.


DOUBLE RIFLE SHOOTERS SOCIETY
 
Posts: 16134 | Location: Texas | Registered: 06 April 2002Reply With Quote
  Powered by Social Strata  
 


Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia