Just picked one of these up. Would like to get some favorite loads from anyone willing to share same...

Appears Wilson does not make a trimmer holder for this case? Have looked around and cannot find anyone who carries it...Guess I'll have to send them a case?

Here is the info on a load I am taking to Namibia next month. My Ruger #1 in 9.3 X 74R is shooting 1" groups with the following:
Norma brass, Fed. 210 primer, 57 grains of IMR 4064 behind a Barnes 250 gr. XXX. The 250 Barnes solids loaded with the same menu shoot same POI. I also get good results out of this rifle with 286gr. Privi's, Nosler Partitions, Barnes XXX and Barnes solids. No chrono results, just good accuracy. Hope this helps.

Larry Sellers
SCI Life Member

I used 56 grs. of RL-15 for everything between 270 gr. Speers and 320 gr. Woodleighs.

You shouuld start lower and use a chronograph. Higher than "nominal" velocities means higher than necessary pressure, and probably higher than maximum pressures.

Here are "nominal" velocities:

Wt. Vel
270 2500
286 2430
300 2370
320 2300


Most of my loads were typically somewhat slower than it's "nominal" velocity, at 80 F.

I don;t shoot a 9.3 but do have a wildcat 338x74K based on the 9.3 case. I can only suggest you get hold of some RWS brass. It is much thicker in the web area & lasts show no signs of head sep. after 5 firings. The Norma brass I was using would show head sep after 5 firings & gets tossed. I love the #1, good luck with yours.

Wouldn't you know it.....Bought a bunch of Norma brass.....Thanks for the help everyone....Gives me a head start for sure....