THE ACCURATERELOADING.COM MEDIUM BORE RIFLE FORUM

Accuratereloading.com    The Accurate Reloading Forums    THE ACCURATE RELOADING.COM FORUMS  Hop To Forum Categories  Rifles  Hop To Forums  Medium Bore Rifles    Testing for a Solid load in the 9,3x74R

Moderators: Paul H
Go
New
Find
Notify
Tools
Reply
  
Testing for a Solid load in the 9,3x74R
 Login/Join
 
one of us
posted
My 9,3x74R Chapuis shoots 285 Hawk .035jkt,
286 Woodleigh Softs, and 286 Nosler Partitions all in the same group at 100 yards with 65gr. of IMR 4831.
I went to the range to see if I could get 286 Woodleigh Solids to "regulate" and hopefully hit in the same group at 100 yards as the others.
I loaded and shot 4 rounds of the following powder charges with the listed results.
All powder charges hit right on for elevation.

63gr. Right bbl 3" right, left bbl 4" left.

63.5gr All shots hit the aiming point forming a group 1" wide by 2" tall. The left bbl shots hit above the right.

64gr. Right bbl hit center, left bbl hit 6" left.
64.5 Right bbl hit center, left bbl 5" left.

This is the typical pattern for this rifle, once both bbls "regulate", if the powder charge is increased the right bbl stays centered and the left shoots wider to the left.
So based on this test 63.5gr with the Woodleigh Solids shoots into the exact same group as my trio of softs. Now I will load some more and test them with the iron sights and at other distances.

[ 07-20-2003, 02:13: Message edited by: N E 450 No2 ]
 
Posts: 16134 | Location: Texas | Registered: 06 April 2002Reply With Quote
one of us
posted Hide Post
sounds like your there!

Few do this, but the first thing one should do with a double is shoot a couple of individual groups with each barrel....Whatever barrel shoots the "worst" is what the gun is capable of doing, end of story...Thought this was as good a place as any to bring that out......Then you know what your after.
 
Posts: 42226 | Location: Twin Falls, Idaho | Registered: 04 June 2000Reply With Quote
one of us
posted Hide Post
"63.5gr All shots hit the aiming point forming a group 1" wide by 2" tall. The left bbl shots hit above the right."

That is magnificent!! do not expect much better from a double SXS. Course you can tweak with OAL by playing seating depths but it is just for fun cause only a pipsqueak would be missed by a 1X2 inch kill zone!!

great shooting. wish my SXS double were that close, and we keep working on them for fun.

Only my overunder doubles do better
 
Posts: 902 | Location: Denver Colderado | Registered: 13 May 2001Reply With Quote
one of us
posted Hide Post
I'm with Ray on this. My Valmet shoots solids to the same point as Nosler partitions with the same load.
 
Posts: 1275 | Location: Fla | Registered: 16 March 2001Reply With Quote
  Powered by Social Strata  
 

Accuratereloading.com    The Accurate Reloading Forums    THE ACCURATE RELOADING.COM FORUMS  Hop To Forum Categories  Rifles  Hop To Forums  Medium Bore Rifles    Testing for a Solid load in the 9,3x74R

Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia