One of Us
| Hogue and Pachmayr make rubber grips for the SBH with the squared trigger guard. Didnt see any for the SBH Hunter. Might e-mail either and see what they say.
Those who would give up essential liberty to purchase a little temporary safety deserve neither liberty nor safety (1759)
|
| | | Posts: 110 | Location: Baghdad Iraq, Caldwell Idaho | Registered: 15 November 2007 | 
IP
|
|
One of Us
| I have the one with the round trigger gaurd.I will look around and see if I can find one.Just thought I would ask here to maybe give me a starting point to know where to look. |
| | | Posts: 39 | Location: Tuscola,Tx | Registered: 30 July 2006 |
IP
|
|
new member
| i have a SBHhunter and it raps me at the knulckleof the middle finger i too would like a good set of grips i am thinking of puttingt a spacer under the right grip to change the spot
where the joint meets the trigger guard but if anybody better idea sing out as i am open to suggestions |
| | |
One of Us
| There is a SBH Hunter and a Bisley Hunter. The SBH Hunter DEFINITELY DOES NOT use a Bisley gripframe. It uses the SBH gripframe with the only difference being a rounded rear to the trigger guard. |
| | | Posts: 272 | Location: North Carolina,USA | Registered: 17 August 2004 |
IP
|
|
new member
| There are a couple of good grip makers on ebay.. for the life of I can not remember thier names... they can make one for you semi-cheaply... I bought one for my 41mag SBHH... fits well, and is a pleasure to shoot
NAHC Life Member since 1985
"If you aint been whipped worse then this, then you aint been around long enough for your opinions to matter"
|
| | | Posts: 23 | Location: Lake Wales, FL | Registered: 22 July 2004 |
IP
|
|
