THE ACCURATERELOADING.COM FORUMS


Moderators: Mark
Go
New
Find
Notify
Tools
Reply
  
Re: Using a pistol .357 bullet in a .35 Whelen
 Login/Join
 
one of us
posted
try it on a coyote! no exit hole and turns em' to mush
158 hornys do the trick........ in my 350 mag they work great.
woofer
 
Posts: 741 | Location: vermont. thanks for coming, now go home! | Registered: 05 February 2002Reply With Quote
one of us
posted Hide Post
I used jacketed pistol bullets in my 358 Winchester when I was breaking in the barrel. Of course I wasn't trying for accuracy then.

Bob257
 
Posts: 434 | Location: Pennsylvania, USA | Registered: 22 November 2002Reply With Quote
new member
posted Hide Post
Thanks for all the help guys! This will give me a bit more direction. Hopefully this will allow more trigger time at both paper targets and small critters while saving a few $$$.

Thanks,
Big Iron
 
Posts: 23 | Registered: 10 February 2004Reply With Quote
one of us
posted Hide Post
I use jacketed .357 pistol bullets all the time in my 35 Whelen Ackley Improved.

I don't meter or weigh charges. I just use the Lee plastic measuring cups/scoops with IMR-4064 powder.

I use this to fireform the 35 Whelen brass to the AI version.

I also use it as an opportunity to practice offhand shooting at 25 and 50 yards at beer cans, bottles, etc.

It is plenty accurate for plinking. I don't reset my scope.

Obviously with using plastic scoops for measuring there is variation from cartridge to cartridge, but it doesn't seem to be enough to effect off-hand shooting accuracy.

Garrett
 
Posts: 987 | Location: Orlando, FL | Registered: 23 June 2003Reply With Quote
new member
posted Hide Post
One more question.
Would the difference in bullet diameters have any affect on the bbl. If I understand things correctly the bullet dia. of the .35 Whelen is .358 and the .357 is well, .357 so would the smaller diameter bullet .001 allow gases to pass by the bullet and possibly cause excessive bbl wear? I understand the pressures and velocity are going to be very low but are the low enough to prevent damage?
 
Posts: 23 | Registered: 10 February 2004Reply With Quote
one of us
posted Hide Post
Most ".357" bullets are .358, I use Oregon Trail cast bullets, 180gr flat points. A couple grain of bullseye will move it about 750-800 fps with about the same noise as a .22, great for popping coyotes close to the house. I also use 125 jacketed HP's and about 15 grs of blue dot for squirels, dont push them to fast or the will disenegrate (the squirels start breaking up at about 1500fps the bullet at about 2200fps)
 
Posts: 107 | Location: Brentwood, CA, USA | Registered: 08 February 2001Reply With Quote
  Powered by Social Strata  
 


Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia