Go | New | Find | Notify | Tools | Reply |
one of us |
I've been asked to load these for a friend. I'm going to start from book but was wondering If any one wants to share a pet load. He's shooting a rem 700 stainless. Thanks in advance. [ 06-24-2003, 10:13: Message edited by: boilerroom ] | ||
|
one of us |
My .300 Win petload for my Blaser R93 (25" bbl.)consists of : 165 Sierra GK / N 160 / 73.5 (CCI 250). It's at the high end (3179 ft"), so approach with caution. | |||
|
one of us |
I shoot 76.5 grains of RL22 and federal 215 primers in my 300 win mag. And get .5 inch groups at 100. the rifle is a custom single shot remington 700 action, douglas 26" barrel set in a McMillan stock. good luck and good shooting. | |||
|
one of us |
RL-22 From 66.9 grains to 79.5 grains Winchester WLR Primer | |||
|
one of us |
Here are a couple of my loads. These are absolute max loads but show no pressure signs in my rifle. H-S Precision Pro Hunter 26" barrel. Definitely start a few grains below this in your rifle. 165gr Nosler Ballistic Tip, 3.45 cartridge OAL 79grains RL 22 powder, federal magnum match primer average velocity 3405 .75" 3 shot groups 165gr Nosler Ballistic Tip, 3.45 cartridge OAL 80grains H4831sc powder, federal magnum match primer average velocity 3380 3 shots in 1 hole groups | |||
|
one of us |
300WM 165gr SGK. IMR 4831 74gr. Fed 210 M primer COL 3.50 This load shoots consistant 5 shot groups at 100 yds. you can literally cover with a dime...sakofan.. [ 06-25-2003, 02:46: Message edited by: sakofan ] | |||
|
one of us |
Can't remember the data, and too lazy to go get it right now, but with RL 22, within book specs, and a 165 grain ballistic tip or partition ( either one) I chronographed the loads right at 3300 to 3350 out of my Browning A Bolt 300 Mag, with a 26 inch barrel. Accuracy is definitely varmint quality, so it will be laser sharp on anything bigger. I believe the Nosler manuals list RL 22 with a velocity of 3290 with that powder. Check out the reloader pages that Mr. Riccardelli ( hope I did not massacre his name too bad) refers to in his posts, they are a wealth of information. They just don't mention velocities. | |||
|
one of us |
PS, If you are using that load for game, I would highly recommend the partitions or Barnes X over the Ballistic Tips, unless blood shot meat is not a problem or concern. At that velocity the BT will definitely give you a good bit of it. | |||
|
one of us |
Seafire. My friend wants to use that for a deer load. I'll pass that on to him. | |||
|
one of us |
I agree with what Seafire said about hunting with the Ballistic Tips. I don't use them to hunt. Too much bloodshot meat. For hunting I use the Nosler Partition, I go one grain lower on the powder and lose about 25fps. I get one hole groups with that bullet and the same loads listed above (-1 grain of powder) also. | |||
|
Powered by Social Strata |
Please Wait. Your request is being processed... |
Visit our on-line store for AR Memorabilia