THE ACCURATERELOADING.COM FORUMS


Moderators: Mark
Go
New
Find
Notify
Tools
Reply
  
First semi inlet
 Login/Join
 
new member
posted
I'm getting ready to do my first semi inlet. Its a large ring 98. Does anyone have any tips, suggestions, or techniques?
 
Posts: 12 | Registered: 13 May 2004Reply With Quote
one of us
posted Hide Post

Buy a set of the long inletting guide screws, and take your time.
Good Luck!
 
Posts: 217 | Location: Michigan | Registered: 20 December 2002Reply With Quote
one of us
posted Hide Post
Inlet the trigger guard first,make sure your tools are sharp.If you have a loose mauser receiver,use it first.Once its inletted,switch to your barreled receiver and inlet the barrel.
 
Posts: 146 | Registered: 25 April 2004Reply With Quote
Moderator
Picture of jeffeosso
posted Hide Post
EO,
welcome to the forum...

my advice? for what it's worth
1: have your wife hide the dremel tool from you.. you will be tempted to use it... DONT

2: go very very slow

3: use a barrel bedding tool.. this will make your life FAR easier
http://www.brownells.com/aspx/NS/store/ProductDetail.aspx?p=6796&title=BARREL+BEDDING+TOOL

or

http://www.brownells.com/aspx/NS/store/ProductDetail.aspx?p=6797&title=BARREL+BEDDER+JR

4: you did put up the dremel, right?

Jeffe
 
Posts: 40030 | Location: Conroe, TX | Registered: 01 June 2002Reply With Quote
one of us
Picture of tiggertate
posted Hide Post
Purchase copies of "Professional Stockmaking" by David Westerbrook and/or "Stockmaking" by Alvin Linden. There are others as well but if funds are short I would get Westerbrook's first. Read it cover to cover two or three times before you start. And do what Jeffe said... toss the dremel. About the only thing it will work with are the three little sintered carbide burrs (cone, ball and cylinder) but you have to have a reversible foot pedal to follow the grain or you're repositioning more than you're working.
 
Posts: 11142 | Location: Texas, USA | Registered: 22 September 2003Reply With Quote
one of us
posted Hide Post
Good advise so far. The dremel works best to tweak the glass bedding if required.

The only thing I would stress is take material out SLOWLY. It is easier to remove than it is to replace.

Take your time, go slow, and most important, have fun!

ASS_CLOWN
 
Posts: 1673 | Location: MANY DIFFERENT PLACES | Registered: 14 May 2004Reply With Quote
One of Us
Picture of Wstrnhuntr
posted Hide Post
Get yourself some inletting black if you havent already, it will save you a lot of grief. It is amazing when you really do get close just how big a difference a sliver removed from just the right place can make, and how ugly a seemingly small scrape from the wrong place can make your work look.

The advice to do the bottom metal first is correct and the pins are absoloutly essential. The closer you get, the slower you need to go.
 
Posts: 10188 | Location: Tooele, Ut | Registered: 27 September 2001Reply With Quote
  Powered by Social Strata  
 


Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia