THE ACCURATERELOADING.COM FORUMS


Moderators: Mark
Go
New
Find
Notify
Tools
Reply
  
What to throw from a 25'06
 Login/Join
 
One of Us
Picture of Croberts
posted
I am going to start reloading for a 25.06. What have you guys had good sucess with for a place to start. It is going to be used for Whitetails so I need at least 100gr's. I was thinking along the lines of the 110 accubond. What other bullet and powder suggestions would you think would be worth a try?
Thanks,
Charlie


A man should never stop learning, so a man should never stop asking questions
 
Posts: 164 | Location: Abingdon Va. | Registered: 09 March 2005Reply With Quote
One of Us
posted Hide Post
I use the 110 gr Accubonds and Ballistic tips. They have worked well for me on whitetails. I got the best results with H1000.
 
Posts: 428 | Location: Bozeman, MT | Registered: 04 January 2005Reply With Quote
one of us
Picture of ricciardelli
posted Hide Post

5 shots, 200 yards

Bullet: Sierra 120 Grain Hollow Point Boat Tail
Powder: 52.5 grains of Hodgdon H-4831
Primer: Winchester Large Rifle
Case: Remington
Firearm: Ruger 77R
Optics: Leupold 3.5x10
Velocity: 2922 FPS @ 15' from muzzle



5 shots, 200 yards

Bullet: Nosler 120 Grain Spitzer Boat Tail
Powder: 53.3 grains of Hodgdon H-4831
Primer: Winchester Large Rifle
Case: Remington
Firearm: Ruger 77R
Optics: Leupold 3.5x10
Velocity: 3076 FPS @ 15' from muzzle
 
Posts: 3282 | Location: Saint Marie, Montana | Registered: 22 May 2002Reply With Quote
One of Us
Picture of vapodog
posted Hide Post
Hornady's 120 hollow point has been a very good bullet for me.


///////////////////////////////////////////////////////////////////////////
"Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery."
Winston Churchill
 
Posts: 28849 | Location: western Nebraska | Registered: 27 May 2003Reply With Quote
one of us
Picture of Reloader
posted Hide Post
I've Only owned 2 25-06s and I've only been hunting w/ the cartridge for two seasons. In that limited experience both rifles shot the 115 grn NBT well w/ IMR 7828 and I've shot two deer w/ those bullets. Both deer were shoulder shot and full penetration was achieved.

The 110 ABs have about the same profile as the 115 NBTs but, some say they can't achieve the same accuracy w/ the AB. I've got some of the ABs, just haven't had the time to test them.

Good Luck

Reloader
 
Posts: 4146 | Location: North Louisiana | Registered: 18 February 2004Reply With Quote
one of us
posted Hide Post
I agree with Reloader - the 115 gr. Nosler partition and IMR-7828 is a great combination. I use 54.5/IMR-7828, Rem. brass, and a Fed. 215 primer. This is a maximum load in my rifle, so start a little lower. It has worked great on at least a dozen antelope, several deer, 2 elk, and some coyotes. I think the rifle is generally too small for elk, but these were both 1-shot kills. This load is my favorite load for my Rem. 700 Classic. It has worked well in at least three other .25-06s owned by friends.
 
Posts: 781 | Registered: 03 January 2004Reply With Quote
one of us
posted Hide Post
Powder: H4831. I got a 0.93" 5 shot group at
300 yards..forget how much as I
don't have the rifle anymore, nor
shoot a .25-06.
Best Regards, Tom
 
Posts: 262 | Location: Wyoming, U.S.A. | Registered: 11 November 2004Reply With Quote
One of Us
posted Hide Post
I'd be for working with these 3, one of them should perk quite well.

R22

7828

H4831

Good luck

Mark D
 
Posts: 1089 | Location: Bozeman, Mt | Registered: 05 August 2005Reply With Quote
One of Us
posted Hide Post
I have good results with the 100gr. Sierra Gameking with about 52-53gr of IMR 4350 for deer, not real expensive but good performance, also just the plain ole Remington Pointed Soft Point is also a great performer.
 
Posts: 79 | Registered: 16 October 2005Reply With Quote
One of Us
Picture of smedley
posted Hide Post
110 AccuBond worked perfect on the 3pt to 8pt (depending on where ya live) whitetail. It created a wound channel that did the job needed for a clean dispatch. It is sitting on top of a load of H4831.
I haven't completely come to a "perfect" load with powder and primer combo yet but I plan on staying with the 110grn AccuBond.

Smedley


______________________

Smedley

______________________
From Audacity of Hope: 'I will stand with the Muslims should the political winds shift in an ugly direction.'
B.H.Obullshitter
------------------------------------
"Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery"
Winston Churchill
------------------------------------
"..it does not require a majority to prevail, but rather an irate, tireless minority keen to set brush fires in people's minds.." Samuel Adams
------------------------------------
Facts are immaterial to liberals. Twisted perceptions however are invaluable.
------------------------------------
We Americans were tired of being thought of as dumb, by the rest of the world. So we went to the polls in November 2008 and removed all doubt.....let's not do it again in 2012 please.
 
Posts: 3242 | Location: Cruising through the Milky Way at 98,000fps | Registered: 03 October 2005Reply With Quote
one of us
posted Hide Post
Most 25-06 rifles are pretty easy to please. They seem to shoot well with any reasonable combination of powder and bullet.

I shoot one a lot, mine is on its second barrel.

My favorite load is a Remington case, Fed 210 primer, 54 grains of IMR 4831, and a Nosler 100 grain Partition.

I just shot some of that load this week, just to check point of impact, going hog hunting soon. A three shot group of that load measured an even half inch. Good enough, I think, especially since the bullets were seconds I picked up from Nosler.

I have not tried the Accubonds in this rifle. I have had mixed results with the Accubonds in several other calibers. Having said that, my buddy routinely shoots them in both, a .257 Wby Mag and a 25 WSSM.


R Flowers
 
Posts: 1220 | Location: Hanford, CA, USA | Registered: 12 November 2000Reply With Quote
one of us
Picture of BigNate
posted Hide Post
I have been using two bullets in mine lately. The 117gr Hornady SST and the Barnes 115gr. XLC. The Hornady bullets were seconds and I've not achieved the accuracy I wanted.
The Barnes XLC I got on a "inventory reduction sale". They shoot so well I wish I'd have gotten more! I picked up several boxes but don't see them listed any more. They may have been discontinued.

A friend of mine used the Sierra 120gr HPBT exclusively. I have used it in my .257 Roberts as well. It does seem to be one of the best bullets for this caliber. Because of this, I'd recommend trying it first, pushed with H4831 and go from there.

I have tried Retumbo, IMR 7828, RL22, and H4831. My .25-06 load is the 115 gr. Barnes XLC, RL22, WLR primer, Win cases. It shoots very well, and I used it to take a very nice buck this fall with great results. Nate
 
Posts: 2376 | Location: Idaho Panhandle | Registered: 27 November 2001Reply With Quote
  Powered by Social Strata  
 


Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia