Any of you guy's have a small surface grinder w/mag plate. That you could take off between 0.0385-0.0400 from the neck end of a Wilson Case Holder for me. Real reasonable, like in cheap (grin).

Phil

[ 12-24-2002, 09:58: Message edited by: Greyghost ]

Just got done talking with the guy's over at Willson's, and asked them what they'd charge to face one off for me. His imediate reply was "Nothing" just send it to us. I then asked if they'd sell direct to the public, and his reply was "Of Course". So I ordered 4 of the 303 Brittish case holders, which their going to face off for me removing .035, .040, .045, 050 respectivly from the neck end. He even went so far as to ask me what the length of the holder was I was using so far. Saying that each batch varied slightly. I told him it was 1.502. Their going to hand pick 4, face them for me, and get them in the mail today. After I gave them my Name and Address, and waiting to give them my Credit Card #. He says don't worry, when you get them you can send us a check.

Now that's what I call a friendly company, and a pleasure to do business with.

Phil

Greyghost, they are a great company. Fortunately for me their shop is 25 miles from my home. Hard to beat.