The Accurate Reloading Forums
excessive leading

This topic can be found at:
https://forums.accuratereloading.com/eve/forums/a/tpc/f/2511043/m/7031046441

23 November 2010, 22:28
usps
excessive leading
i get heavey leading in the last 2 inches of the muzzle in my sxs d.r. after only one shot. im using wheel weight lead cast lead bullets .430 in. @ 1400fps i slugged the barrel and it is .429-.430 should i go to a .428 bullet or ??? any suggestions?
23 November 2010, 22:53
Von Gruff
I would look at changing your alloy to 50/50 ww/PB and sizing it to 431 so you get full obduration for a better fit in your barrel.

Von Gruff.


Von Gruff.

http://www.vongruffknives.com/

Gen 12: 1-3

Exodus 20:1-17

Acts 4:10-12


23 November 2010, 22:53
Larry Gibson
What cast bullet and lube specifically?

Larry Gibson
24 November 2010, 00:20
Lamar
the bbl could start out at a larger dimeter and get smaller at the muzzle.
i'd measure a bit more then i'd look at what lube i was using.
if home made, you can lighten the viscosity of the lube.
24 November 2010, 00:48
usps
i cant remember what lube was used i ordered them from midway but i will try some .431 50/50 cast bullets and see what happens. thank you
24 November 2010, 09:16
Sagebrush Burns
Leading near the muzzle is usually an indication of lube issues - maybe not enough lube, maybe the wrong lube for the job.
24 November 2010, 19:44
243winxb
Your need a .431" to .432" bullet. Alloy needs to be harder with Tin added. Good lube helps. Adding antimony/tin will make a larger diameter bullet as it drops from the mold. Lee INfo > Cast bullet leading

A clue to what is causing the leading is where the leading first begins to appear. If it appears near the chamber, chances are that bullet diameter or hardness are the cause.

A diameter too small and/or too hard an alloy will allow high pressure gas to leak past the bullet, which erodes the bullet and leaves leading near the chamber.

If the leading first appears on the leading edge of the rifling (if you imagine the bullet being pushed through the barrel, you will note that one edge of the rifling does most of the work of imparting a spin to the bullet. This is the edge you see when you look through the barrel from the breech end) the bullet might be too soft, and/or the velocity too high.

If the leading appears in the second half of the barrel, the bullet is running out of lube. You should see a star shaped pattern of lube accumulate on the muzzle. This is an indication that there is a little excess lube.
24 November 2010, 23:11
butchloc
normally i expect leading at anything much over 12-1300 fps