It's been a while (15 years+)since I've managed to stick a case in the resizing die. But I've managed to do it (again). Lost the instructions that came in my RCBS box. So, now I'm struggling to remember what the instructions say. It's an RCBS stuck case remover, and I would appreciate any help.

Looked at the RCBS website and didn't find it there. Could email them a question, but am hoping this forum can give me a faster answer.

Thanks !

1)Unscrew the decapper and let it drop back into the case
2)Unscrew the die, then screw it into the press upside down
3)Drill the primer hole out with the drill bit supplied
4)Tap the hole with the 1/4 X 20" tap suppled
5)Place the cup shaped extractor over the die body, drop the WELL LUBRICATED Allen bolt through the cup and thread it into the case head
6)As the bolt advances it will extract the case

Hope this helps.

Geronimo

I've stuck so many cases, I now use a slide hammer and Kroil -works every time.