Perusing some of the old Handloading Digests showed me that there used to be several available, including the Lee, Lyman 310 Tong Tool, Wilson Pak-Tool, & Pacific Pak-it among others. Are any of these still avaiable, how good do they do?
Am looking for one with the following priorities:
1. Accuracy of ammunition produced
2. Speed
------------------
Orange Gunsite Family Member, NRA Life member, Varmint Hunter Assn. and American Legion member
"An armed society is a polite society" -Robert Heinlein via Jeff Cooper
Just a couple of points. If you want to go the lyman route, TRY to get the old style STEEL tongs. The newer ones were aluminum and were crap. The steel is much stronger and better to use.
Secondly, I suspect all the "hand tools" for reloading only NECK size. I know the Lyman do. Neck sizing means your cases need to be from YOUR gun only and you better not have an automatic because then the brass needs to be full length resized.
I would recommend you go with at least an inexpensive bench press. Lee makes good quality for the money. Much faster and more simple to use, IMHO.
------------------
A well placed bullet is worth 1,000 ft/lbs of energy.
Does anyone know if the Pak-Tool by WH Wilson is still available anywhere?
------------------
Orange Gunsite Family Member, NRA Life member, Varmint Hunter Assn. and American Legion member
"An armed society is a polite society" -Robert Heinlein via Jeff Cooper
Must you use Lyman 310 dies in the 310?
Is it still being sold?
If I bought the 310, I would need 22/250, 25/06, and 25/06AI dies. Are these available?
I have one of the Lee tools which uses the standard loading dies. It works fine, although FL sizing some cases can give you a bit of a workout. I have not tested cases sized in the Lee vs. sized on my regular press to see if the case neck runout is the same.
The biggest hassle of loading away from home is measuring powder. If you don't want to measure volumetrically, then you need a scale--and that's the tough part. They are all affected by the wind, and the electronic ones may be affected by temp changes.
------------------
I know the next rifle will be perfect.......
It will full-length size, and uses standard dies. But it's tedious, and not very conveniant.
I bolted my presses on a 2 X 12 about two feet long. I C-clamp this to my work-bench, but it also is portable and clamps to my shooting bench out in the field -- or with some padding, to the tailgate on the truck.
I bolted my Uniflow measure to the same board between two single stage presses. I set up the "bell" die or neck die in one press, charge with the Uniflow, and seat in the next press.
The Pacific Press ran me $20 at a pawn shop. I got the "universal" ram for $10 at a gun show.
I mounted my case trimmer on a 2 X 4 and clamp that to the bench just like the presses. This makes me completely portable.
Set up the scales in the back of the pickup, under the canopy. I cover mine with a clear plastic storage container. Pretty much let's me weigh stuff in a hurricane.
------------------
.223 Ackley Improved Wildcat Forum:
http://www.hotboards.com/plus/plus.mirage?who=223ackleyimproved
[This message has been edited by Genghis (edited 04-30-2002).]