THE ACCURATERELOADING.COM FORUMS


Moderators: Mark
Go
New
Find
Notify
Tools
Reply
  
Sticky Powder???
 Login/Join
 
One of Us
Picture of glockmeister71
posted
A few minutes ago I tried to load some 22-250 with Benchmark.The powder was sticking to the funnel and case necks so bad I had to give it up.I poured the powder out into a bowl and stirred it good,but it didn't help.My bench is in a A/Ced room with the thermostat set on 71F.The powder is about 4-5ft away from a vent on the floor,but it's blocked by the bench top,shelve top and surrounded by 3 sides.I've prolly got about 5 years of reloading experience and never had this happen.Any ideas?
 
Posts: 145 | Location: Knoxville,TN. | Registered: 12 April 2006Reply With Quote
one of us
posted Hide Post
You have static cling. Wipe your funnel with a fabric softener sheet. The ones used in the clothes dryer.
 
Posts: 868 | Location: maryland | Registered: 25 July 2004Reply With Quote
one of us
posted Hide Post
I concur, although a quick wash in warm dishwater should also do the trick.
 
Posts: 4799 | Location: Lehigh county, PA | Registered: 17 October 2002Reply With Quote
One of Us
Picture of glockmeister71
posted Hide Post
I tried the fabric softener sheet and it took care of my funnel.Brushed all my necks with a new bore brush and took care of them.Simple fix.Thanks guys.
 
Posts: 145 | Location: Knoxville,TN. | Registered: 12 April 2006Reply With Quote
  Powered by Social Strata  
 


Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia