I am having a 6mm Remington built and it will have a tight chamber/neck. I will have to turn the necks. I am a fairly high volume shooter and am looking for a neck tool that I can use a low RPM drill to speed up this processs. Looking for suggestions.

Thanks.

K &M. Sincliar is not bad, I own one. If I had it to do over it would the K&M. A cordless screwdriver works real well. A drill spins cases too fast and the cuts are not accurate. Russ Haden and Bruno shooters keeps them in stock. Might want to look at investing in a tubing mic, Holland makes one the will do down to 17. Midway I think has them pretty cheap for down to 22cal. I have got away with just using feeler gauges. A tubing mic is on the short must haves list. K&M makes a dial indicator attachment for theirs. Both cost about them same.

About 2 weeks ago, www.benchrest.com had a discussion about neck turbers.