Has anyone heard or have info if anyone is going to make a batch of the 7 MM STW brass? My supply is getting low and round count on what is left is going up. Had to trash a few more cases again the other day do neck splits and case head separation signs.

In pinch, you could get some 8mmRemmag brass & neck it down. FWIW, if you are getting head seps, your dies need to be adjusted so the case is headspacing off the shoulder not the belt.

Thanks, I have corrected loading procedures after realized I was hurting my brass, just shortened the life of the brass I had already loaded a few times. I can always do 8 MM brass in a pinch, just prefer proper head stamp. Have resized some 300 Weatherby brass that I pick up here or there for spares.

quote:

In pinch, you could get some 8mmRemmag brass & neck it down

My 7STW wouldn't know what to think if I ever stuck a 7STW case in it. Only brass it has ever seen is 8mm necked down.

What is the problem getting the brass? Does anyone know?

Does'nt Nosler or Hornady make this size?

quote:

Originally posted by Croberts:
What is the problem getting the brass? Does anyone know?

Remington is only making seasonal runs. I'm sure it's sim. for any other manuf. Youy could always BUY factory ammo & use the brass.

Sinclairintl.com shows to have it in stock in Remington. Did not look under other brands.

Some of the brass companies have done some manufacturing lately. A lot of the places that were out of stock for the non-usual sizes like 375 H&H seem to have stuff in stock now.

I think Arms & Ammo has some in stock currently.

A&A Link

Bob

quote:

Originally posted by Bob in TX:
I think Arms & Ammo has some in stock currently.

A&A Link

Bob

Thanks Bob, check out my post in the American Big game hunting section on the hunt we had this weekend.