The Accurate Reloading Forums
Reloder 15 and the 30/30

This topic can be found at:
https://forums.accuratereloading.com/eve/forums/a/tpc/f/2511043/m/594109731

08 June 2004, 11:07
Dogger
Reloder 15 and the 30/30
Might anyone suggest a good whitetail deer load with Reloder 15? I will be reloading for a Marlin 336CS with 20 inch barrel. I have a set of new Lee dies. Haven't acquired any bullets yet. Lots of Remington, Winchester, and Frontier once-fired brass on hand. Various CCI and Remington primers on hand. I have heard that Reloder 15 burns cleanly and will work very well in the 30/30, but most often I hear of IMR 3031, H322, or H335 as the powders of choice.

The clean burning characteristics of Reloder 15 really caught my attention.

Thanks.
08 June 2004, 11:16
Mauser98
If you go Here and scroll down to .30-30, you'll find what yor're looking for.
08 June 2004, 11:37
Reloader
Good Luck w/ that 336 30/30. I have tried several loads thru mine and have only been able to achieve 2" 100 yard groups at best.

2" groups are very satisfactory for a brush gun but, it sure is nice to get tight clusters.

That Marlin 336 has put more big bucks on the ground than any other rifle I currently own. Just goes to show that the big boys like the thick brush.

I once killed a 135" 8 point after a pass thru on a 2" sapling 10 feet in front of the buck. The bullet was mushroomed (big entrance hole) and only pentrated about 1/2 way through the buck but, that was enough to drop him in his tracks. Ever since then I have felt very confident in toting the ole' "Dirty-Thirty" into the woods.

My best groups have come w/ H380 and H4895 w/ Rem 150 CLs.

I have tried the HDY 170s and I wouldn't recommend them to anyone (very big groups w/ several powders).

I have heard the Speer 30-30 bullets are good in the accuracy department.

Good Luck!

Reloader
08 June 2004, 12:04
BlueMoon
Reloader, I'm lucky to get 2" groups with my M336 but still love to shoot it. One of my most accurate loads was with a 170 grn bullet and a max charge of IMR4895. I've had my 30/30 for years and have tried just about all the powders in it with cast gc'ed and jkt bullets but I can't remember if I ever used H380. I would like to hear more about your experience with it. BM



Bill



PS: edit-Dogger, H322 has also worked very well for me it my M336 with a 20" barrel.
08 June 2004, 14:46
jstevens
My best load in an old 94 Winchester is 33 gr. of RL15 with a 170 Hornady bullet. Mine are loaded in R-P cases with CCI200 primers and chronograph 2130 fps. In my receiver sighted 94, it never shoots over 1.5 at 100 yds for 3 shots, many groups are around 1". It won't vary 4 fps over the chronograph. This rifle groups 2.5-3" with Remington factory ammo, so go figure that out. I use the RL15 in .375 H&H, 9.3x62 and .30-30, just a powder that seems to work well in any case of small to moderate capacity related to bore size.