I'm looking to buy a progressive loader to load pistol shells. Anything that could help load 10mm shells would be appreciated. Thanks.

I don't load for 10mm, but I load and have loaded for 9mmLuger, 9mmMakarov, 38Spec, 357Mag, 40S&W, 41Mag, 45ACP, 45LC, 380ACP on my Hornady L-N-L AP. I am not saying I have never had any issues with this press but I will say the problems I have had were easily resolved. This press loads consistent ammo pull after pull but the key to this is using ball powder (which covers about any pistol propellent) so that the powder charges are uniform.

I've used a Star Progressive in 9mm Luger and a Dillon SDB in 9mm Luger. I've also seen being used the Dillon 550, 1000 and the Hornandy Pro-Jector.

I like the Dillon SDB because it automatically indexes the cartrdige when you pull the lever. Thus you cannot double charge a cartridge if distracted as when it charges on the downstroke it advances away from the powder charge station.

The Dillon SDB comes set up from the factory. Mine I bought as a 9mm Luger and and then changed to it 44 Magnum with a different shellplate, dies, and large primer size feed.

It was a PITA to do...changing primer feed, shellplate, all the dies and etc...but once it is set up then it is fine.