THE ACCURATERELOADING.COM FORUMS

Accuratereloading.com    The Accurate Reloading Forums    THE ACCURATE RELOADING.COM FORUMS  Hop To Forum Categories  Guns, Politics, Gunsmithing & Reloading  Hop To Forums  Reloading    Hornady Lock n Load conversion kit installation question

Moderators: Mark
Go
New
Find
Notify
Tools
Reply
  
Hornady Lock n Load conversion kit installation question
 Login/Join
 
One of Us
posted
Hi all,
Just purchased the conversion kit for my old Rock Chucker press. For those of you who have done this, how do you go about installing the press bushing. I'm going to put some loctite thread lock on it, but is finger tightening good enough? If not, what do you do to tighten the bushing? Thanks!
 
Posts: 26 | Location: UPSTATE New York | Registered: 03 September 2013Reply With Quote
One of Us
Picture of dpcd
posted Hide Post
You will need to tighten it fairly tight with a wrench; finger tight won't do.
 
Posts: 17371 | Location: USA | Registered: 02 August 2009Reply With Quote
  Powered by Social Strata  
 

Accuratereloading.com    The Accurate Reloading Forums    THE ACCURATE RELOADING.COM FORUMS  Hop To Forum Categories  Guns, Politics, Gunsmithing & Reloading  Hop To Forums  Reloading    Hornady Lock n Load conversion kit installation question

Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia