Hi Everyone,

New to reloading and purchased some once-fired brass and so far have annealed it and have trimmed it to below max case length. They are .30-06 and have been trimmed all to 2.484 (minimum) or a tad higher (most 2.486).

My question is this: While cutting, the bit seemed to be a bit dull, could this be what I suspect might be partly accountable to the difference in case length when trimmed?

I have been looking for a new cutter head for my hornady trimmer (bought it used) and so far have not been able to find one. Lyman and RCBS have them I can find online. Will those fit my hornady trimmer?

Thanks

Replacment cutter:

http://www.hornady.com/store/C...immer-Cutter-1-Each/

I called up RCBS and they sent me one.