The Accurate Reloading Forums
AA#7

This topic can be found at:
https://forums.accuratereloading.com/eve/forums/a/tpc/f/2511043/m/50510495

18 July 2002, 14:07
jim81147
AA#7
I am thinking of using this on some pistol loads and was wondering how it runs through your powder measure. I have some military surplus that uses AA#7 data but it wont run through the RCBS powder measure that I have . The flakes are too large and thick.Thanks.
18 July 2002, 17:03
Big_R
Jim:

You didn't mention what caliber/weight you were reloading for. I use AA powder exclusively and I have found that AA#5 is a better choice for moderate pistol loads and AA#9 is far superior for heavy pistol loads. My opinion on AA#7 is it probably could be dropped from their product line. Just my opinion.

Ryan
18 July 2002, 23:25
<stans>
I have some AA#7, but I have never found a good use for it. AA#5 and AA#9 seem to leave no gaps in the velocity range, so why #7? I think it was developed specifically for military use in the 9mm.
19 July 2002, 00:52
KTS1
I use AA #7, got a good deal on it.
for the 9mm i use 8.5 gr with a 124gr bullet and for the 357 i use 9.5gr with 158 gr bullet.
Both of these are quite accurate in my guns.

I use a RCBS Ammo master and have never had a problem with this powder metering right.
Wes
19 July 2002, 03:16
jim81147
I was thinking of using this powder on some 9mm loads with 124 gr bullets, 357 mag loads with 158 gr. bullets and 44mag loads with 240 gr. bullets.
19 July 2002, 06:14
<Dyno>
Jim,
The powder that you refer to is not an AA powder,it is just compared to AA#7 for burn rate.
I buy powder from a surplus supplier that has a thick flake said to compare to old AA#7 powder.
Accurate Arms says that AA#7 powder has always been a fine flake powder.The AA#7 was originally for nato 9mm carbine ammo,I use this powder for 40S&W mostly and some 357 mid-range loads.I use a lot of AA#5 and WC-820 (surplus powder) which loads and looks just like AA#9. All AA powders go through my Dillon ,Lyman and RCBS powder measures just fine.If you have already purchased it just ,your RCBS should handle it by cutting those large disc or flakes just like cutting extruded powders ,it just won't be fast as measureing ball powders.

Hope this helps.
Dyno