The Accurate Reloading Forums
Rough Redding die?

This topic can be found at:
https://forums.accuratereloading.com/eve/forums/a/tpc/f/2511043/m/491107991

05 February 2005, 04:55
<JOHAN>
Rough Redding die?
Gentlemen

I have a little problem. One of my FL dies is making lots of very shallow vertical scratches on all once fired brass.

Is it possible to fix this problem?

Cheers
/ JOHAN
05 February 2005, 05:38
lawndart
Chuck up a tight fitting bore mop (you can cover it with a large patch). Put a bunch of Flitz brand metal polish on the mop and run it in and out of the die with the drill spinning everything pretty fast.

lawndart


05 February 2005, 07:49
YUMAN
If it is an RCBS, just send it back to them.
They will send you a new one.
I have sent a number of them that I have bought used that were scratched, They just replace them.
Good luck
Lyle


"I would remind you that extremism in the defense of liberty is no vice. I would remind you also that moderation in the pursuit of justice is no virtue."
Barry M Goldwater.
05 February 2005, 18:49
Terry Blauwkamp
Send it back to Redding, I'm sure they will repair or replace it.


Remember, forgivness is easier to get than permission.