THE ACCURATERELOADING.COM FORUMS


Moderators: Mark
Go
New
Find
Notify
Tools
Reply
  
PMC Brass any good
 Login/Join
 
OLBIKER
One of Us
posted
I was looking at some once fired PMC 9MM Brass.Does anyone have any experience with this brass???Thanks,OB
 
Posts: 4372 | Location: NE Wisconsin | Registered: 31 March 2007Reply With Quote
ramrod340
one of us
Picture of ramrod340
posted Hide Post
I've run a bunch of it through my 45ACP and some through my 223. Only issue I had the brass seemed a touch thicker than some of my other ACP. I lost count how many times the acp was reloaded. Most just phased out as I lost it at the range. I would have no issue using it again.


As usual just my $.02
Paul K
 
Posts: 12881 | Location: Mexico, MO | Registered: 02 April 2001Reply With Quote
p dog shooter
one of us
posted Hide Post
I loaded a ton of it back in the 80s worked well.
 
Posts: 19711 | Location: wis | Registered: 21 April 2001Reply With Quote
wasbeeman
One of Us
posted Hide Post
I've only used it in the .223. Worked fine there.


Aim for the exit hole
 
Posts: 4348 | Location: middle tenn | Registered: 09 December 2009Reply With Quote
Bob from down under
One of Us
Picture of Bob from down under
posted Hide Post
I found it OK in 9mm.


Regards,
Bob.
 
Posts: 480 | Location: Australia | Registered: 15 August 2007Reply With Quote
  Powered by Social Strata  
 


Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia