I'm reloading a 6mm Rem in a 700 BDL. I've never had a problem before but now I can only load the brass twice. After that I can't close the bolt even after FL resizing it. Do I have a bad lot of brass ? My load has not changed 45.3 of IMR 4831 with 100gr.bullets. The old brass was Win. Now I'm using Rem.
Posts: 1111 | Location: Edmond,OK | Registered: 14 March 2001
As George stated - Gotta be the dies. Break out the micrometer and start measuring your fired brass VS new brass. Check shoulder, OAL, etc, etc, etc. You should find the problem quickly. If you don't already have one, get a Stoney Point ALO Gage ASAP.
Posts: 10780 | Location: Test Tube | Registered: 27 February 2001
Does your sizing die bump the shell holder? If it doesn't set it so it touches the shell holder and then give it another 1/8 turn and try another shell. Over and above that advice (which is real basic) I wouldn't be able to venture another guess.
Take one case that has been re-sized and will not chamber - remove the expander ball and re-size again. Now see if it will chamber. If it will the problem is neck thickness. If it won't the problem is at the shoulder or case length.
Got it. I readjusted the die and did as Mike suggested. I guess I got a little careless when I put the die in and the shoulder was to far forward. Thanks to all
Posts: 1111 | Location: Edmond,OK | Registered: 14 March 2001