22 June 2006, 00:27
NetwarrenBrass advvice for 300 win mag
just purchased a 300 win mag. Will anyone share experience with what brands of brass worked well and what brands did not? thanks.
22 June 2006, 01:40
MasteriflemanOpinions are like "noses", everyone has one. Mine is that I have found of all the domestically produced brass, I like Winchester the best. Do I use others? Certainly! But, I still prefer Winchester. Do I believe that Lapua, Norma and RWS are better? Yes! But, not for the price. If foreign brass is the only way to get what you need, buy it. I prefer Winchester!
Just a note,unless your bench rest shooting,there is not that much advantage in the more e xpensive brass IMHO> Winchester,Rem,and Federal all is good brass.but be careful when you reload,and don,t mix up your brass if you have more than one kind. As different brass has different volumes to it and even if your using the same amount of powder,you will get different results,due to this.So, reload the same brass,and don,t mix them. van
22 June 2006, 13:55
Jonathan TomlinsonI still await delivery of my .300 rifle, (on order since December 05 for delivery end of Feb 06!!!!)
Here in the U. K brass is available from amongst others Lapua and Winchester.
Lapua brass is of extremely high quality and can be loaded straight from the box. Often the Winchester arrives here in plastic bags and as a result the case mouths are often out of round, some even "D" shaped. that said a quick passs through the sizer die rectifies this.
Other than that I can buy exactly 400 W-W cases for the price of 100 Lapua (U.K prices) and having used Win brass in other calibres from .222 - .458 would have no hesitation in recommending them to you. Also a small point to bear in mind is there is plenty of load data out there for .300 Win Mag and a high percentage of it is based upon standard ingredients, one of which is nearly always W-W brass!
22 June 2006, 17:22
NetwarrenThank you for the information on brass. This information is very helpful.
22 June 2006, 17:26
ReloaderIf you are going for the bargain brass(Win Rem Fed) just about any will do. I personally get better accuracy in my 300 w/ Rem brass w/ win being close behind. The three have weight variances. I prefer win or rem over fed, federal usually has less capacity.
Good Luck
Reloader
22 June 2006, 19:41
iwzbeemanI prefer Remington but I'm sure any one of the rem/win/fed would work well for you.
23 June 2006, 21:01
Woodrow SI use the R-P nickle plated brass and it has held up to multiple loadings well and offers very good accuracy too. The nickle does start to wear off after repeated visits to the vibe case cleaner though but that just goes to show how many loadings you can safely get. I would not use anything else.