THE ACCURATERELOADING.COM FORUMS

Accuratereloading.com    The Accurate Reloading Forums    THE ACCURATE RELOADING.COM FORUMS  Hop To Forum Categories  Guns, Politics, Gunsmithing & Reloading  Hop To Forums  Reloading    Nosler Balistic Tip 100 grain in 6.5 x 55 load data?

Moderators: Mark
Go
New
Find
Notify
Tools
Reply
  
Nosler Balistic Tip 100 grain in 6.5 x 55 load data?
 Login/Join
 
new member
posted
Does anyone have any load data for the Nosler Balistic Tip 100grain in 6.5 x 55?
 
Posts: 7 | Location: UK | Registered: 25 September 2003Reply With Quote
one of us
Picture of Deerdogs
posted Hide Post
UKreloader

I have a load that is very accurate in my rifle:

Lapua cases, federal primer, 50 grains of Reloader 19. it shots into about .6 of an inch. 22 inch barrel MV is 2950 fps. It is seated waaay back from the lands as the rifle has quite a long throat.

I no longer use this combination for deer as I found the meat damage unacceptable. A good fox, vermin load IMO. I suppose I could slow it down and reduce the damage, but I have sweet loads in 125gr PT and 160gr RN for things I intend to eat.

What are you shooting with it?

[ 09-25-2003, 15:57: Message edited by: Deerdogs ]
 
Posts: 1978 | Location: UK and UAE | Registered: 19 March 2001Reply With Quote
new member
posted Hide Post
Thanks for your reply. I bought some to try primarily as a fox load but depending on how they perform was considering using them on Roe / Munty.
 
Posts: 7 | Location: UK | Registered: 25 September 2003Reply With Quote
one of us
posted Hide Post
Don't know the FPS but I have put up to 51.5 grains of 2209 in them. I usally run 49.5 for about 1 inch groups. I've found that they explode apart, I can't recall any actually holding together. I've shot a shit load of goats from 10-50kg with them. They drop-em and some even kill like the Hammer of Thor, but I would not shoot anything heavy boned or in weight, there just to explosive
 
Posts: 30 | Location: close | Registered: 28 August 2002Reply With Quote
one of us
posted Hide Post
I reload for a CZ 550 LUX in 6.5X55 with 24 inch bbl and work up from 47.5 to 50.0 grs of W760 at a COL of 3.010. Start velocity is 3101 and top is 3306 fps. If you have a MIL type 6.5 work up to 3100 and stop there. Accuracy is sub MOA when I do my part and use strong optics.

Note that the Nosler BT is really spinning in the fast twist of the 6.5 at these velocities and will blow up a deer. The Nosler 100 gr Partition is better.
 
Posts: 1111 | Location: Afton, VA | Registered: 31 May 2003Reply With Quote
one of us
posted Hide Post
I once read somewhere that faster powders like IMR 3031 and Varget work wonderfully with these lighter bullets in 6.5x55, yielding excellent velocity and accuracy. I use H4831SC with heavy 140-grain match bullets in that cartridge, so I'd definitely go to a faster powder for 100-grain bullets.
 
Posts: 254 | Location: Vancouver, Canada | Registered: 10 April 2003Reply With Quote
one of us
posted Hide Post
I have a Remington 700 Classic in 6.5x55. I load 41.0gr. of IMR4895 in it with the Nosler 100gr
Bal.Tip. It gives me a MV of 2700fps. and is loaded out to 3.001". 5 shot groups at 100yds. print a group of .948". I no longer use this load as I've switched to Lapua Scenar bullets in 108, 123 and 139grs. pushed along by VV550 and 560 powders. The accuracy is much better with these Finish components. All in all I find the 6.5x55 to be about the best rifle caliber I own. Best wishes.

Cal - Montreal
 
Posts: 1866 | Location: Montreal, Canada | Registered: 01 May 2003Reply With Quote
one of us
posted Hide Post
Was just playing with that last week. I like mid range powders, IMR 4064, IMR 4895, RL 15, H 380. I did see something that listed 47.5 grains of IMR 4064. Out of a 22 inch barrel Ruger that chronographed at 3350 to 3375 with a 100 grain Ballistic Tip.

The bullet was seated out as far out as there was still some part of the brass to hold unto the bullet.

Accuracy in a 1 in 8 twist Ruger was excellent.

I also load 43.5 grains of 4064 in my 260 Remington, which also chronographs at 3350s fps.
It was a load I originally got from Nosler, before they came out with their latest book.

Good luck!
[Cool] [Roll Eyes] [Razz]
 
Posts: 2889 | Location: Southern OREGON | Registered: 27 May 2003Reply With Quote
one of us
posted Hide Post
Well I use this bullet a LOT on muntjac roe and fallow.

42gr VVN150
Rem brass
WLR primer
COL about 2.95 or so
3000fps
Has yielded .26MOA for 3 shots at 100 and 200 (witnesses by Deerdogs) yards

This is the Nosler max book load which was the most accurate for the bullet in the previous manual.

I find damage acceptable.

[ 09-26-2003, 15:28: Message edited by: 1894 ]
 
Posts: 2258 | Location: Bristol, England | Registered: 24 April 2001Reply With Quote
one of us
posted Hide Post
Sounds like something I might look into. I'm looking for a light bullet with good precision. Anybody tried the 120 gr BT?
 
Posts: 544 | Location: Sweden | Registered: 27 October 2001Reply With Quote
one of us
posted Hide Post
Here are my120 gr Nosler BT MAX loads for the 6.5X55 in my CZ 550, 24 inch bbl:

W760: 45.0 grs 3.040 COL, 2938 fps.

H4350: 49.0 grs 3.060 COL, 3008 fps

R19: 50.0 grs, 3.010 COL, 3064 fps.

All loads use Win large rifle primers.

Note that the 129 gr Hornady generally shoots to the same velocity at the same pressure and very closely duplicates the 130 gr 270 Win from a 22 inch bbl.
 
Posts: 1111 | Location: Afton, VA | Registered: 31 May 2003Reply With Quote
one of us
posted Hide Post
quote:
Originally posted by Wachtel:
Sounds like something I might look into. I'm looking for a light bullet with good precision. Anybody tried the 120 gr BT?

Herr Wachtel:

I also use the 120 grain Ballistic tips. That load has its best accuracy with IMR 4064, RL 15, IMR 4895 out of my rifles. 4064 and RL 15 are my choices. RL 15 is made in Sweden there.

Max velocity I get with that bullet is 44 grains of W 748 and a mag primer. In a 26 inch rebarelled Winchester Featherweight, the Velocity is 3250 fps. I use Winchester brass on this, and do not know how it compares to Norma which I am sure you use in Sweden. That load was from out of an older load manual I found, so if you do try it, work it up. Accuracy is not fair to say out of this rifle. It has a PacNor barrel done by Kevin Wyatt of Medford Oregon. Anything down the bore has been real accurate in this rifle.

Good luck
[Cool] [Roll Eyes] [Razz]
 
Posts: 2889 | Location: Southern OREGON | Registered: 27 May 2003Reply With Quote
one of us
posted Hide Post
After some load development i have settled on

N160
51 grs

3200fps from a 23 inch barrel.

1/2 inch at 100 yrds.
 
Posts: 35 | Location: Iceland | Registered: 17 April 2003Reply With Quote
  Powered by Social Strata  
 

Accuratereloading.com    The Accurate Reloading Forums    THE ACCURATE RELOADING.COM FORUMS  Hop To Forum Categories  Guns, Politics, Gunsmithing & Reloading  Hop To Forums  Reloading    Nosler Balistic Tip 100 grain in 6.5 x 55 load data?

Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia