primer pocket cleaner

The Accurate Reloading Forums

This topic can be found at:
https://forums.accuratereloading.com/eve/forums/a/tpc/f/2511043/m/212105437

21 September 2007, 00:38

GSP7

primer pocket cleaner

I need a new primer pocket cleaner bit.

Which is a good one?

What about the Forster? I cant find a picture of it.

Got to replace this RCBS wire one

21 September 2007, 00:53

Ol` Joe

I use the RCBS wire brush on my case master and find it works well for me. I`ve use the Lee and found it too small for my likeing. I cleaned for years with a small screw driver and it was as good as any for a hand tool IMO.

------------------------------------
The trouble with the Internet is that it's replacing masturbation as a leisure activity. ~Patrick Murray

"Why shouldn`t truth be stranger then fiction?
Fiction after all has to make sense." (Samual Clemens)

"Saepe errans, numquam dubitans --Frequently in error, never in doubt".

21 September 2007, 01:14

arkypete

I bought one of the primer pocket uniformers.
I uniformed all of my primer pockets and I use the tool to clean the crud out each time load the case.
Jim

"Whensoever the General Government assumes undelegated powers, its acts are unauthoritative, void, and of no force." --Thomas Jefferson

21 September 2007, 01:16

GSP7

Looks like the Forster aint what im lookin for.

I chuck my rcbs in a drill but it just isnt fast enough. Maybe i should rough up the wires alittle. Seems like it would work beter with finer wires.

21 September 2007, 02:49

steve4102

This is what I use.

http://www.sinclairintl.com/cgi-bin/category.cgi?catego...em=UN-8KP&type=store

21 September 2007, 05:52

Buliwyf

I use a uniformer instead of a brush. Brass flows into the primer pocket during each firing, so I re-uniform and clean.

21 September 2007, 18:52

Paul Reed

Ditto for me too on the uniformer...I use the Sinclair and it does a very thorough job. Run it in your hand drill on slow speed.

"Diligentia - Vis - Celeritas"
NRA Benefactor Member
Member DRSS

22 September 2007, 19:18

tnekkcc

I use the Uniformer instead of a brush.
I just ordered an ultrasonic cleaner, so I can get more anal about brass

It is inside the necks that bothers me. I don't want my bullets getting scratched.

http://www.6mmbr.com/ultrasonic.html