I was reading in the Richard Lee manual that his powder dippers "when used as directed" will maintain within 1/10gr. This is the sdame accuracy my powder scales claim. Can any of you guy's substantiate this claim? Thanks

I have a set of them and don't get that degree of accuracy. Getting a consistent dip of powder is tricky if you compress it any it will read differently. All of my lee dies come with a powder dipper and a chart listing different powders to use. If you don�t have a powder charger they work "ok" pour the dipped charge in a powder weight scale and use trickle charger to finish. For the price you cant go wrong but I wouldn�t say that they can be counted on for true consistent accuracy IMHO.

i have a set of lee dippers, i put the spout of a lyman scale pan on the dipper and pour powder into the dipper till it overflows, than gently shake off the excess. results are no better or worse than charges thrown by a lyman accu measure, but is quicker and easier to use and a whole lot cheaper. i load hangun loads in the mid range for practice.

If they are claiming "within .1 grain", they are totally out to lunch, or they have some secret method they haven't shared yet, at least for rifle loads.

If you shake it level, and sight across the top, you'll get one answer. If you scrape it level with a straightedge, you'll get another.

That is why they recommend reduced loads when using the powder scoops.

They are not near that accurate.

They are a very good tool in loading rifle rounds. You can get real close w/ a scoop and trickle the rest.

I have used them in my Savage Smokeless Muzz. w/ good success but, it depends on the powder and how finicky it is. Some powders will shoot differently when there is small deviations in powder weights but, some do fine as long as you are w/in a few 10ths +/-.

Be careful when using the Lee charts, I find my weights to differ quit a bit w/ some powders. The charts do give you a good "ball park" figure w/ most powders.

Good Luck!

Reloader

I use them...to dip out charges into the pan of my powder scale.....

I use them all the time for loading reduced loads where you want to ensure that you do not get a double charge. As far as accuracy, it really depends upon the specific powder your are using, the technique you use and to some degree the specific dipper (large or small). I can easily get the same accuracy as I do from a powder measure with the right combination. Also if you load far enough below maximum than +/-1gr is not a big deal with a powder like IMR4831 in some cartridges.

I use them as a powder dribbler cause they work better than an accual powder dribbler. The only time I tried them vs. a scale they were close but not +/- .1 gr.
If you read Lees newest loading book he states that 'most all' the loads in his books were developed using dippers and converted to grains for the book. He also gives very specific methods for using them..........

I used then in my savage ML but when I started using a scale my groups tightened up some, I use them now to rough messure a load into the pan of my 505 then as a trickeler to finish

I use them to measure buffer for my shotshell loads.... Dutch.

I use them in conjuction with a couple of digital scales, one with a dispenser and a Pact with the trickler. I can dump a scant load in the scales, hit the "Dispense" and it dumps the few tenths of a grain necessary for the charge to be dead on very quickly. I don't find them that accurate although when using ball powders they can dip pretty close. I wouldn't use them as compared to a powder measure.