THE ACCURATERELOADING.COM FORUMS

Accuratereloading.com    The Accurate Reloading Forums    THE ACCURATE RELOADING.COM FORUMS  Hop To Forum Categories  Guns, Politics, Gunsmithing & Reloading  Hop To Forums  Reloading    Large Pistol Magnum Primers in place of Large Rifle?

Moderators: Mark
Go
New
Find
Notify
Tools
Reply
  
Large Pistol Magnum Primers in place of Large Rifle?
 Login/Join
 
One of Us
Picture of 308Sako
posted
Well I gave this a try as the load I was working on was a relatively low pressure load, and I though... What the hell?

Thing of it is, the damn load shot awesome... now what? Interestingly I was chronographing at the time and the Pistol primers gave about 40 ft/sec less than the CCi BR's.

Anyone else ever try this lunacy?






Member NRA, SCI- Life #358 28+ years now!
DRSS, double owner-shooter since 1983, O/U .30-06 Browning Continental set.
 
Posts: 3611 | Location: LV NV | Registered: 22 October 2002Reply With Quote
One of Us
Picture of seafire2
posted Hide Post
All the time...

especially in the low velocity and low recoil loads..

usually try and keep with loads that pressures are estimated to be under 40,000 psi..


Life Member: The American Vast Right Wing Conspiracy

Jan 20, 2009.. Prisoner in Dumocrat 'Occupied America', Partisan in the 'Save America' Underground


Beavis..... James Beavis..... Of Her Majesty's Secret Service..... Spell Check Division



"Posterity — you will never know how much it has cost my generation to preserve your freedom. I hope you will make good use of it."
John Quincy Adams

A reporter did a human-interest piece on the Texas Rangers. The reporter recognized the Colt Model 1911 the Ranger was carrying and asked him "Why do you carry a 45?" The Ranger responded, "Because they don't make a 46."

Duhboy....Nuttier than Squirrel Poop...



 
Posts: 9316 | Location: Between Confusion and Lunacy ( Portland OR & San Francisco CA) | Registered: 12 September 2007Reply With Quote
one of us
posted Hide Post
One difference between rifle and handgun primers is that handgun firing pins have less energy therefore the primers are thinner and softer than rifle primers. Using handgun primers in a rifle therefore risks primer penetration !! Primers like any other variable may give different results for different brands.
 
Posts: 7636 | Registered: 10 October 2002Reply With Quote
One of Us
posted Hide Post
I use LP in my cast bullet rifle rounds loaded with R/D. They are all very low velocity rounds in the 1400/1500fps range w/R Dot powder. I started using them because I had no LR primers at one time and had excellent accuracy results and have stuck with them since, but only for these loads. I use them in the 30-06, 8mm Mauser, 8x56M/S and 35 Whelen with the reduced CB loads only. I've checked all the rifles to make sure they didn't have excess fireing pin protrusion too after the 35 Whelen punctured one on the second shot with an overly long fireing pin that's been adjusted now. No further incidents.
 
Posts: 567 | Registered: 08 June 2008Reply With Quote
One of Us
Picture of 308Sako
posted Hide Post
For what it is worth, I am doing the unthinkable and guessing that since I am approximately 3 grains under maximum that my pressures as Seafire points out are below the 40K PSI Roll Eyes

The cartridge is the .243 Ackley and the powder is IMR 7828 with a 90 gr Berger BTHP; at least the volume is mostly used up.






Member NRA, SCI- Life #358 28+ years now!
DRSS, double owner-shooter since 1983, O/U .30-06 Browning Continental set.
 
Posts: 3611 | Location: LV NV | Registered: 22 October 2002Reply With Quote
One of Us
Picture of seafire2
posted Hide Post
You'd have to test it, my only reservation would be to wonder if the large pistol primer had enough spark to ignite that much of a slow powder reliably and consistency, shot to shot..

pressure wouldn't be an issue with the load, but reliable ignition would....


Life Member: The American Vast Right Wing Conspiracy

Jan 20, 2009.. Prisoner in Dumocrat 'Occupied America', Partisan in the 'Save America' Underground


Beavis..... James Beavis..... Of Her Majesty's Secret Service..... Spell Check Division



"Posterity — you will never know how much it has cost my generation to preserve your freedom. I hope you will make good use of it."
John Quincy Adams

A reporter did a human-interest piece on the Texas Rangers. The reporter recognized the Colt Model 1911 the Ranger was carrying and asked him "Why do you carry a 45?" The Ranger responded, "Because they don't make a 46."

Duhboy....Nuttier than Squirrel Poop...



 
Posts: 9316 | Location: Between Confusion and Lunacy ( Portland OR & San Francisco CA) | Registered: 12 September 2007Reply With Quote
One of Us
Picture of 308Sako
posted Hide Post
Seafire, I ran 20 rounds of this load and it is holding 1/2 MOA or better, though it is still showing a touch of vertical. The reason I choose the magnum version of the large pistol was to light it up.

The chronograph shows this load with the LPM primers to be more consistant as to SD (12 vs 17) for std large rifle match. Since later this AM I scored some F215match at a gunshow... I am going to run several different primers with no other variable and see what happens.

At this rate soon I will be using cannon fuse and matches... Roll Eyes






Member NRA, SCI- Life #358 28+ years now!
DRSS, double owner-shooter since 1983, O/U .30-06 Browning Continental set.
 
Posts: 3611 | Location: LV NV | Registered: 22 October 2002Reply With Quote
  Powered by Social Strata  
 

Accuratereloading.com    The Accurate Reloading Forums    THE ACCURATE RELOADING.COM FORUMS  Hop To Forum Categories  Guns, Politics, Gunsmithing & Reloading  Hop To Forums  Reloading    Large Pistol Magnum Primers in place of Large Rifle?

Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia